Technical data

LVD TEST REPORT
Report Numbe r : KSQ-LVD 081010
Clause Requirement - Te st Result - Remark Verdict
Page 26 / 63
24.3
Switches intended for all-pole disconnection of
stationary appliances are directly connected to the
supply terminals and having a contact separation in
all poles, providing full disconnection under
overvoltage category III conditions
No switch es N
24.4
Plugs and socket-outlets for extra-low voltage
circuits and heating elements, not interchangeable
with plugs and socket-outlets listed in IEC 60083 or
IEC 60906-1 or with connectors and appliance
inlets complying with the standard sheets of IEC
60320-1
No plugs and socket-outlets N
24.5
Capacitors in auxiliary windings of motors marked
with their rated voltage and capacitance and used
accordingly
No capac itors N
Capacitors in appliances for which 30.2.3 is
applicable and that are permanently connected in
series with a motor winding, are of class P1 or P2 of
IEC 60252
N
Voltage across capacitors in series with a motor
winding does not exceed 1,1 times rated voltage,
when the appliance is supplied at 1,1 times rated
voltage under minimum load
N
24.6
Working voltage of motors connected to the supply
mains and having basic insulation that is
inadequate for the rated voltage of the appliance,
not exceeding 42V.
No such motors N
In addition, the motors are complying with the
requirements of Annex I
N
25
SUPPLY CONNECTION AND EXTERNAL FLEXIBLE CORDS
25.1
Appliance not intended for perman ent connection to
fixed wiring, means for connection to the supply:
N
- supply cord fitted with a plug
Not intended to be permanently
connection to fixed wiring
N
- an appliance inlet having at least the same degree
of protection against moisture as required for the
appliance
N
- pins for insertion into socket-outlets N