Specifications

TIPS & HINTS

GENERAL

Failure to program keys on CPH systems can be caused by corrosion

to the large brown loom connector on the O/S inner wing or a melted

pin in the large round connector situated on the n/s inner wing

(below battery or air filter)

Saxo on CPH systems have a very slow learn time, after successfully

programming keys, remove the AD100, turn the ignition off and

leave the vehicle alone for 30 mins.

C5- if the battery has been disconnected or gone flat, after replac-

ing/re-connecting the battery it will be necessary to leave the vehicle

for approx 2 minutes before it can be started- during this time do

not switch the ignition on.

All Saxo and Dispatch vehicles are CPH remotes and keys are there-

fore programmed separately.

If a pin code has been entered incorrectly three times the ignition

must be left ON for 20 minutes and then OFF for 5 minutes before

you try to program the keys again.