Specifications

TIPS & HINTS

BOXER EMERGENCY START

This emergency procedure enables you to start the engine only if the engine

doesn’t start because of an immobiliser problem.

If the procedure is interrupted, you must do it again. That’s why it is important

to read and understand properly the procedure before practising it.

This procedure must be done for each starting.

Procedure

1. Read the security code on the card

2. Switch off the ignition. Switch on the ignition

3. Press the accelerator pedal till the diagnostic light switch off (around 8 secs)

4. Release the accelerator pedal

5. Press the accelerator pedal as soon as the number of diagnostic light flashing

equals the first number of the security code

6. Press the accelerator pedal till the diagnostic light switch off (around 4 secs)

7. Do stages 6 and 7 for each number of the security code

8. Once you have released the pedal accelerator for the last number if the light

switch off or flash for 4 seconds, the procedure is a success and the engine can

be started.

If the diagnostic light stays on , the procedure has failed and must be done

again after a delay of 10 minutes. Start the procedure stage 2. If the procedure

succeeds and the engine starts, it means that the problem is an immobiliser

one.

PEUGEOT 607—BSI

To minimise the possibility of the BSI unit corrupting it's own software after

download/programming or disconnection a certain procedure must be adopted

to sleep and wake the BSI in the cleanest possible way. This will prevent the

possibility of a complete dashboard or BSI derived electrical failure and also a

current draw problem caused by failure to enter power save or sleep mode.

Switch off all electrical devices and put drivers window down. Make sure the

AD100 is disconnected (a diagnostic session will keep the BSI unit awake) and

make sure the bonnet is up, the key is out of the ignition and all of the doors

are shut. Wait for 3 minutes. Disconnect the battery and wait for 30 seconds

Re-connect the battery, wait 10 seconds and without opening any doors turn on

the sidelights through the drivers open window. (the "lights on" chime should

sound). Start the engine and check all systems are functioning. Sudden voltage

spikes (as with jump starting) can also corrupt the BSI unit. Some 607 vehicles

have two batteries (other one is in the boot under the R/H rim)