Specifications

277

TIPS & HINTS

VW-AUDI-SEAT-SKODA

1. When reading Pin codes from vehicle memory, if loss of commu-

nications is experienced, try reading fault codes, then clearing

fault codes then read the pin code.

2. If when programming keys, the AD100 displays the following :—

KEYS PROGRAMMED : 136

This means the incorrect PIN CODE has been entered.

KEYS PROGRAMMED : 0

This means that the PIN CODE has been entered incorrectly more

than three times, and the system will need resetting by leaving the

ignition ON for 35 minutes.

EMERGENCY START

1. Switch IGNITION ON and turn the clock set button to the right

and at the same time press and hold the trip reset button for 1

second.

2. “0000” appears on the display, press the trip button to input the

first digit of the pin code. Turn the clock set button to the right

to move to the next digit. Repeat for all 4 digits.

3. Then with the correct pin code entered turn the clock set button

to the right and press the trip reset button for 1 second.

4. The Immobiliser light will stay on, and the car can run for 45

minutes.