Specifications

259
SPECIAL FUNCTIONS
ADD MASTER KEY
ADD VALET KEY
23
ADD MASTER KEY
SWITCH IGNITION OFF
REMOVE MASTER KEY-
WITHIN 20 sec
AND THEN PRESS ENTER
TIME ELAPSED : 1 S
ADD MASTER KEY
INSERT NEW MASTER KEY
WITHIN 10 Sec
LEAVE IGNITION OFF
AND THEN PRESS ENTER
TIME ELAPSED : 0S
ADD MASTER KEY
TIME ELAPSED : 2 S
Read carefully and follow the screen prompts.
Read carefully and follow the screen prompts.
This usually takes about 60 seconds. If the
timer goes past 120 seconds, stop. The key is
now likely programmed. Disconnect AD100 and
test key.
NOTE : If you get an error message screen,
disconnect the AD100 and remove the key.
Wait 20 seconds and start again. On this type,
each key must be added separately. Disconnect
the AD100 from the vehicle and remove the
key. Wait 20 seconds., and then ADD the next
key.
ADD MASTER KEY
PROCEDURE COMPLETE
TIME ELAPSED : 59 S
PRESS ENTER KEY
RESET IMMOBILISER
ADD MASTER KEY
ADD VALET KEY
ERASE KEYS
DIAGNOSTIC MENU