Specifications

256
GENERAL OPERATION
LEXUS IMMOBILISER—REMOTE CONTROL(On board)
ADD REMOTE
Procedure
1. Make sure no keys are in the ignition lock and the drivers door is
open and unlocked.
2. Within 4-5 seconds put the key in the ignition and remove 2 times.
3. Close the drivers door and open 2 times.
4. Put the key in the ignition and remove.
5. Close the drivers door and open 2 times.
6. Put the key in the ignition and close all doors.
7. Turn the ignition ON for 1 second then OFF.
8. Remove the key from the ignition.
9. The power locks should now cycle once.
10. Press the unlock and lock buttons at the same time for 1 second and
then quickly press the unlock and lock buttons for 1 second again.
11. If the remote is programmed the doors will cycle once. If failed the
doors will cycle 2 times.
12. Open drivers door to end procedure.
ERASE REMOTE
Procedure
1. Make sure no keys are in the ignition lock and the drivers door is
open and unlocked.
2. Within 4-5 seconds put the key in the ignition and remove 2 times.
3. Close the drivers door and open 2 times.
4. Put the key in the ignition and remove.
5. Close the drivers door and open 2 times.
6. Put the key in the ignition and close all doors.
7. Turn the ignition ON for 1 second then OFF, then back onto ON for 1
second and then OFF.
8. Remove the key from the ignition.
9. The power locks should now cycle 2 times
10. Press the unlock and lock buttons at the same time for 1 second and
then quickly press the unlock and lock buttons for 1 second.
11. If the remote is programmed the doors will cycle once. If failed the
doors will cycle 2 times.
12. Open drivers door to end procedure.
23