Specifications

205

GENERAL OPERATION

INTRODUCTION

There are 3 different immobiliser systems fitted to the Proton vehicle

range as follows :-

NOTE : Always make sure that you are fully aware of the difference

between Type 2 BLUE keys and Type 3 BLUE keys before program-

ming.

NOTE : When programming Impian keys, the alarm will need pro-

gramming as well, details below.

IMPIAN/JUMBUCK Alarm Fob reprogramming

1. Alram system must be disarmed before procedure using the re-

set switch or ignition key.

2. Turn ignition ON and PRESS & HOLD the alarm reset switch.

3. Turn ignition OFF and remove the key from ignition.

4. Turn ignition ON.

5. Release the ALARM switch, and press ONCE.

6. The alarm LED should flash 2 times during coding.

7. With ignition ON press the LOCK button on the alarm remote

control.

8. The alarm should beep once if programmed.

9. Repeat for additional remote controls.

10. Switch ignition OFF.

NOTE : All existing remote controls will be erased.

FUNCTIONS AVAILABLE

ECU IDENTIFICATION

FAULT CODE READING

FAULT CODE CLEARING

PROGRAM KEYS