Specifications

178
SPECIAL FUNCTIONS
PROGRAMMING PROCEDURE
PROCEDURE FOR WHEN THERE ARE 2 OR MORE PREPROGRAMMED KEYS
1. Cut the mechanical cuts on each new transponder key.
2. Insert the first key and turn the ignition ON and then back to the OFF posi-
tion 5 times. You must NOT leave the ignition in the ON position for more
than 1 second.
3. Turn the first pre-programmed key back to the ON position, the security
light should stay ON.
4. Turn the first key back to the LOCK position.
5. Insert the second pre-programmed key and start the car. The security light
should stay lit for between 1 and 2 seconds. Turn back to the LOCK position
and remove key.
6. Insert the first pre-programmed key and start the car. The security light
should stay lit for between 1 and 2 seconds. Turn back to the LOCK position
and remove key.
7. Insert the next pre-programmed key or a new key and start the car. The
security light should stay lit for between 1 and 2 seconds. Turn back to the
LOCK position and remove key. Repeat for any further additional keys, up
to 8 maximum in total.
8. Stop if you have no more keys, and wait 30 seconds for the car to exit pro-
gramming mode.
HOW TO ENTER THE CODEWORD (PASSWORD)
The Codeword can be obtained by inserting the serial number from the Immobi-
liser ECU into the Mazda Code program on the AD100. The codeword is 8 digits.
(For this procedure we will use : 23234223)
1. Before you start, the security light on the dash should be flashing on and
off for 1.2 seconds each for ON and OFF.
2. Turn the ignition key to the ON position while the security light is not illumi-
nated. Count the illumination flashes 2 times while the light is not illumi-
nated and turn the key to the lock position.
3. Within 30 seconds of turning the key to the LOCK position, turn the ignition
key to the ON position while the security light is not illuminated. Count the
illumination flashes 3 times while the light is not illuminated and turn the
key to the lock position.
14