Specifications

177
SPECIAL FUNCTIONS
MAZDA CODE CONVERTER
KEY PROGRAMMING PROCEDURE
PROCEDURE FOR WHEN THERE ARE NO KEYS OR ONLY 1 PREPROGRAMMED KEY
AND YOU NEED TO PROGRAM MORE KEYS
IMPORTANT : You must have at least 2 keys to perform this procedure. If
there are no pre-programmed keys, you will have to provide 2 new keys. If
there is only one pre-programmed key, you will have to provide at least one
more.
IMPORTANT : YOU MUST USE A FACTORY KEY TO PROGRAM, YOU CANNOT
USE AFTERMARKET KEYS FOR THIS PROCEDURE.
1. Cut the mechanical cuts on each new transponder key.
2. Insert the first key and turn the ignition ON and then back to the OFF posi-
tion 5 times. You must NOT leave the ignition in the ON position for more
than 1 second.
3. Turn the key back to ON position and watch the flashing security light on
the Dashboard. The light should flash rapidly, 300 mS ON and 300mS OFF.
4. Within 20 seconds, turn the key to the LOCK position for 5 minutes. After 5
minutes the security light should decrease in flashing to 1.2 seconds be-
tween flashes.
5. Within 20 seconds, enter the CODEWORD(Password). NOTE : SEE HOW TO
ENTER CODEWORD ON PAGE 2.5
6. When you have entered the codeword, the security light should remain ON
and not flash.
7. The car should now start. Start the car and the security light should stay lit
for between 1 and 2 seconds.
8. Within 20 seconds, remove the first key and insert the second key and start
the car. The security light should stay lit for between 1 to 2 seconds.
9. Stop if you have no more keys, and wait 30 seconds for the car to exit pro-
gramming mode.
14
MAZDA MECS
SER No.
603-611-2057
PINCODE : 7355-4316
PRESS ENTER KEY
The screen will then displayed the
converted pin code.