Specifications

168
GENERAL OPERATION
• Drivers door is unlocked, other doors remain locked.
• Alarm LED flashes slowly
• Perimetric protection is de-activated
• Volumetric protection is de-activated
• Engine and crank functions remain disabled.
The EKA code is a four number code, and each number can be up to 15. This
code is entered by turning the drivers door lock to the numbers of the code.
Procedure for 5-2-9-14
1. Turn the key to the unlock position and wait for 6 MINUTES before proceed-
ing.
2. Turn the key to the unlock position 5 times.
3. Turn the key to the lock position 2 times.
4. Turn the key to the unlock position 9 times.
5. Turn the key to the lock position 14 times.
6. Finally turn the key to the unlock position once only.
If entered correctly the alarm system will unlock all the doors, fully disarm all
systems and allow the vehicle to be started.
If the code is entered incorrect 3 times the system will lock out any further at-
tempts for 30 minutes. If a code is entered incorrectly, then the system can be
reset by opening and closing the drivers door, or turning the ignition on and off.
REMOTE HANDSET (PLIP KEY)
Two plip keys are supplied with the vehicle from new, and if the battery is re-
placed or the vehicle battery is removed the plip keys will require synchronisa-
tion. This is achieved by switching on the ignition, which enables the alarm sys-
tem to send a re-synchronisation code to the handset automatically. Alterna-
tively it can also be achieved by pressing either handset button 5 times quickly
with the ignition OFF.
If the plip key battery is low, then when the signal is sent from the plip key the
alarm will send a signal which sounds a buzzer for 10 seconds and the alarm
LED flashes for 10 seconds to notify the owner.
ENGINE IMMOBILISATION
The engine immobiliser feature disables the starter relay and also the enable
code sent to the MEMS engine management ECU. The passive immobilisation
occurs when 5 seconds after the ignition is turned off and the drivers door
opened. If ignition is just turned off then it will immobilise after 5 minutes. Re-
immobilisation will occur if the plip key unlock button is pressed or the key is in-
serted and ignition turned on with the Plip key within 70 mm of the ignition lock.
If 2 hand sets are in close proximity it will no re-immobilise because of interfer-
ence.
13