Specifications

165

GENERAL OPERATION

VEHICLE STATUS INDICATION

The vehicle status is indicated by the Alarm LED as follows :-

• Slow flash - Immobilised or Armed and Immobilised

• Rapid Flash - Internal sensor system armed

• Intermittent Rapid Flash - Doors, Boot and Bonnet armed

• No flash for 10 seconds - Miss lock

• Continuous - Drivers door open or ignition on and system immobilised

PLIP KEY RESYNCHRONISATION

Procedure.

1. Unlock the drivers door using the key.

2. Ensure all doors, bonnet and boot are shut, and if Central Locking is fitted,

make sure both front doors are unlocked.

3. Press the Plip key (Lock button) four times quickly, until the vehicle locks are

enabled.

PLIP KEY LOW BATTERY WARNING

When the Plip key battery is low, the alarm unit will enter low battery mode. The

alarm LED will flash to indicate low battery, and also the hazard lights will not

flash when the alarm is disarmed.

POWER UP MODE

The alarm will always power back up in the mode it was disabled. So if the bat-

tery is disconnected and the alarm is activated, then it will remember and when

re-connected will enter the same state.

EMERGENCY ACCESS CODE

If the Plip key is lost or does not function, the emergency access code can be

used to override the system as follows :-

1. Using the code turn the key to the unlock the number of times of the first

digit.

2. Now turn the key to the lock position the number of times of the second digit.

3. Repeat for the last two digits.

After the code has been entered, turn the key to the unlock position, and check

to see whether the Alarm LED has stopped flashing, and the engine will start.

If the wrong code has been entered and warning sound will be heard. After 3

wrong attempts a period of 30 minutes must pass before the next attempt is

made. If a mistake is made part way through, hold the key in the lock position

for at least 5 seconds and then begin the code entry again.