USER’S GUIDE COLOR MONITOR Model No : 719BF
IMPORTANT SAFEGUARDS 1. Read all of these instructions. 2. Save these instructions for later use. 3. Unplug this monitor from the wall outlet before cleaning. Do not use liquid cleaners or aerosol cleaners. Use a damp cloth for cleaning. 4. Do not use attachments not recommended by the monitor manufacturer as they may cause hazards. 5. Do not use this monitor near water, e.g., near a bathtub, washbowl, kitchen sink, or laundry tub, in a wet basement, or near a swimming pool, etc. 6.
WICHTIGE INFORMATIONEN Bitte lesen Sie alle diese Informationen, bevor Sie das Gerät in Betrieb nehmen! Lesen Sie sich außerdem die Bedienungsanleitung komplett und sorgfältig durch, da nur in diesem Fall eine problemlose Inbetriebnahme erwartet werden kann. • Achten Sie darauf, daß das Gerät nur in eine 230V Schuko-Steckdose eingesteckt wird. • Die Steckdose sollte jederzeit frei zugänglich sein um bei einem evtl. auftretenden Notfall das Gerät schnell vom Netz zu trennen.
CONTENTS Introduction ............................................................................. 1 Product Features ................................................................. 2 Setup ......................................................................................... 3 Installing the Tilt/Swivel Stand .......................................... 3 Connecting the Signal Cable and Power Cord..................... 4 Operation & Adjustment ......................................................
PRODUCT FEATURES • The convenient and user-friendly on-screen display allows for easy and accurate adjustments of horizontal and vertical screen size and position, geometry, and screen color. SETUP INSTALLING THE TILT/SWIVEL STAND 1. Ensure that the power is off to the monitor. • The monitor supports a safe working environment in strict compliance with the MPR II standard for low emissions. 2. Set the monitor face down with the underside facing you. Please be careful not to scratch the monitor screen.
CONNECTING THE SIGNAL CABLE AND POWER CORD 1. Turn off the computer and monitor. OPERATION & ADJUSTMENT Control Panel 1 POWER 2 POWER Indicator shows both normal operation and power management status with power indicator light. swithes the monitor on and off. 2. Connect the 15 pin D-sub connector to the output port of the video card in your computer. 6 3. Tighten the screws of the connector. 5 2 1 4. Plug the power cord into the AC receptacle located on the back of the monitor. 5.
Key Process OSD Functions ICON CONTROL FUNCTION PINCUSHION Adjust the left and right margins for more convex or more concave margins. TRAPEZOID Adjust the trapezoid of the screen by moving the lines inward or outward. PARALLELOGRAM Adjust the parallelogram when the screen is leaning left or right. Adjust the side balance when the sides of the screen are bowed towards left or right. T. PIN CORNER Adjust the pin corner top when the top sides of the screen are bowed. B.
SPECIFICATIONS ICON CONTROL FUNCTION DEGAUSS Degaussing keeps the monitor free from unwanted magnetism that can result in color impurity. STATUS Display horizontal & vertical frequency and polarity. H. MOIRE Adjust the horizontal picture moire cancellation. V. MOIRE Adjust the vertical picture moire cancellation. LANGUAGE Select language for OSD (5 languages). RECALL Reset the screen to the Factory Preset Display Settings.
TROUBLESHOOTING Symptom No picture. Check Check if power switch and computer power switch are in the on position. Check if the signal cable is correctly connected to the video card. Check if the pins of D subconnector are not bent. Check if the computer is in the power- saving mode. POWER LED is not Check if power switch is in the on position. lit. Check if the power cord is correctly connected. Image is unstable. Check if the signal cable is suitable to the video card.
