USER’S GUIDE COLOR MONITOR Model No : 531X
IMPORTANT SAFEGUARDS 1. Read all of these instructions. 2. Save these instructions for later use. 3. Unplug this monitor from the wall outlet before cleaning. Do not use liquid cleaners or aerosol cleaners. Use a damp cloth for cleaning. 4. Do not use attachments not recommended by the monitor manufacturer as they may cause hazards. 5. Do not use this monitor near water, e.g., near a bathtub, washbowl, kitchen sink, or laundry tub, in a wet basement, or near a swimming pool, etc. 6.
WICHTIGE INFORMATIONEN Bitte lesen Sie alle diese Informationen, bevor Sie das Gerät in Betrieb nehmen! Lesen Sie sich außerdem die Bedienungsanleitung komplett und sorgfältig durch, da nur in diesem Fall eine problemlose Inbetriebnahme erwartet werden kann. • Achten Sie darauf, daß das Gerät nur in eine 230V Schuko-Steckdose eingesteckt wird. • Die Steckdose sollte jederzeit frei zugänglich sein um bei einem evtl. auftretenden Notfall das Gerät schnell vom Netz zu trennen.
CONTENTS Introduction ............................................................................. 1 Product Features ................................................................. 2 Setup ......................................................................................... 3 Installing the Tilt/Swivel Stand .......................................... 3 Connecting the Signal Cable and Power Cord..................... 4 Operation & Adjustment ......................................................
PRODUCT FEATURES • The convenient and user-friendly on-screen display allows for easy and accurate adjustments of horizontal and vertical screen size and position, geometry, and screen color. SETUP INSTALLING THE TILT/SWIVEL STAND 1. Ensure that the power is off to the monitor. • The monitor supports a safe working environment in strict compliance with the MPR II standard for low emissions. 2. Set the monitor face down with the underside facing you. Please be careful not to scratch the monitor screen.
CONNECTING THE SIGNAL CABLE AND POWER CORD OPERATION & ADJUSTMENT Control Panel 1. Turn off the computer and monitor. 2. Connect the 15 pin D-sub connector to the output port of the video card in your computer. 3. Tighten the screws of the connector. 4. Plug the power cord into the AC receptacle located on the back of the monitor. 5. Plug the other end of the power cord into the AC outlet. Signal Cable • • Increase the value of any selected function.
Hot Key OSD Functions ICON BRIGHTNESS CONTROL FUNCTION PINCUSHION Adjust the left and right margins for more convex or more concave margins. TRAPEZOID Adjust the trapezoid of the screen by moving the lines inward or outward. PIN BALANCE Adjust the side balance when the sides of the screen are bowed towards left or right. POWER LIGHT When there is no OSD, if you press this BRIGHTNESS button, you can adjust the brightness directly.
SPECIFICATIONS ICON CONTROL FUNCTION H. CENTER Adjust the position of the display horizontally (left or right) . V. CENTER Adjust the position of the display vertically (up or down). H. SIZE Adjust the width (horizontal size) of the display. V. SIZE Adjust the height (vertical size) of the display. Self Diagnosis When the monitor doesn’t display, if you press any key, Self Diagnosis screen is displayed. Self Diagnosis function checks if the status of the monitor is No Signal or Out of range.
TROUBLESHOOTING Symptom No picture. Check Check if power switch and computer power switch are in the on position. Check if the signal cable is correctly connected to the video card. Check if the pins of D subconnector are not bent. Check if the computer is in the power- saving mode. POWER LED is not Check if power switch is in the on position. lit. Check if the power cord is correctly connected. Image is unstable. Check if the signal cable is suitable to the video card.
