DSC-3210EGB D I G I T A L
ADDITIONAL INFORMATION FOR TV'S SOLD IN GREAT BRITAIN The appliance is supplied with a moulded three pin mains plug fitted with 5Amp fuse. Should the fuse require replacement, it must be replaced with a fuse rated at 5 amp and approved by ASTA or BSI to BS1362. The plug contains a removable fuse cover that must be refitted when the fuse is replaced.In the event of the fuse cover being lost or damaged, the plug must not be used until a replacement cover has been obtained.
CONTENT REMOTE CONTROL & TV CONNECTIONS...............................................3 IMPORTANT SAFEGUARDS.......................................................................4 INSTALLATION............................................................................................4 START UP....................................................................................................5 CONNECTING EXTERNAL EQUIPMENT...................................................5 DAILY USE..................
REMOTE CONTROL & TV CONNECTIONS LOCAL CONTROL Front B2 B7 B1 B2 B3 B4 B5 Rear B8 B9 C3 C1 REMOTE sensor VIDEO INPUT socket AUDIO INPUT (L + R) socket PANEL S-VIDEO jack HEADPHONE socket C2 AV1 C1 C2 C3 B6 B10 B6 B7 B8 B9 B10 MAIN POWER button PROGRAM UP/DOWN buttons VOLUME UP/DOWN buttons TV / AV button STAND-BY indicator ANT B5 B4 S-VIDEO AUDIO VIDEO L Side B3 R B1 AV2 ANT IN SCART 1 socket SCART 2 socket AERIAL jack REMOTE CONTROL UNIT TV mode A1 A2 A3 A4 A5 A6 A7 A8 A9 A10 A
IMPO RT A N T SA FEG U A RD S WATER AND MOISTURE Never install the set in the following places: In a wet basement, bathroom. Do not place any container with liquid on the set. Do not expose the set to dripping or splashing water. HEAT Never place the set near heat sources. Never put a naked flame, such as a candle, on the top of TV set.
ST A RT U P LANGUAGE MENU The very first time that you turn on the TV, the LANGUAGE menu will appear on the screen. Its purpose is to enable you to select the language that will be used for all the OSD (On Screen Display) menus. The user must enter a choice of language before proceeding further. The language entered at this stage can still be modified at any later time, by entering the FEATURES menu (see later section under MENU DESCRIPTION).
DAILY USE SWITCHING ON TV SET 1) If stand-by indicator (B5) is red, then the TV set is in stand-by mode. You can switch on using the remote control POWER button (A1), the NUMBER 0….9 buttons (A3), or PROGRAM UP (A6) / DOWN (A21) buttons. The front panel PROGRAM UP/DOWN buttons (B2) can also be used. Once on, the stand-by indicator turns to green and the picture appears on the screen. 2) If stand-by indicator (B5) is not lit, then the TV set is powered off.
