Specifications

ACG ROTOR PULLER

ACG

HEX BOLT

FLANGE BOLT

A.C. GENERATOR /RH. CRANK CASE COVER

● Loosen the flange nit securing the fly wheel and

remove the flywheel using the A.C.G. rotor puller.

CAUTION

•The flywheel may easily remove if you rotate the

puller while tapping the roller shaft metal hammer.

•Always use a holder and a puller to remove the

flywheel. Do not try to remove the flywheel by

hammering directly on it. The crank shaft or

components could be damaged.

•After disassembling fly wheel, check whether

woodruff key damaged or not.

TOOL: A.C.G ROTOR PULLER

UNIVERSAL HOLDER

DRIVE FACE HOLDER

● Loosen the 2 flange bolts securing stator and

remove the stator.

● Loosen the 2 bolts securing the pulse generator and

remove it.

ASSEMBLY

● Assemble ACG stator to RH. crank case cover.

● Clean crank shaft taper side.

● Clean the inside of fly wheel.

● Check woodruff key, assemble the home of fly wheel

to woodruff key.

DISASSEMBLE

● ACG wire coupler and connecter connected with

wire harness.