Specifications

DRIVEN PULLEY SUB

DRIVEN PULLEY

DRIVE FACE

BELT TYPE CONTINUOUSLY VARIABLE TRANSMISSION / KICK STARTER

DRIVEN PULLEY ASSEMBLY

● Turn right driven pulley ass’y and widen

maximumly assembled home for belt

● Assemble drive belt to drive pulley sub ass’y, then

assemble to drive shaft.

● Assemble clutch outer to driven pulley sub ass’y,

assemble temporarily special flange nut.

● After fixing clutch outer to universal holder, then

fasten flange nut 10mm as the specified torque.

TORQUE : 4.0kgf

TOOL : UNIVERSAL HOLDER

● Assemble LH. Side cover.

MOVABLE DRIVE FACE

REMOVAL

● Disassemble LH. Side cover.

● Disassemble start pinion ass’y.

● Hold the drive face using the clutch center holder

and remove hex nut 12mm and drive face.

TOOL : DRIVE FACE