Specifications

REPLACE DRIVEN FACE BEARING

● Replace inner bearing.

● Remove snap ring, disassemble outer bearing to the

side of inner bearing.

● Assemble new replacement outer bearing.

● Assemble snap ring.

● Apply grease to the designated position of right side

picture.

APPLYING GREASE CAPACITY : 9.0~9.5g

● Assemble new replacement inner bearing.

● Check damage or worn of movable drive face.

● Check whether worn of movable driven face guide

home.

● Measure inner diameter of movable driven face.

SERVICE LIMIT : 34.06MM

● Check worn or damage of driven face.

● Measure outer diameter of driven face.

SERVICE LIMIT : 33.94MM

MOVABLE DRIVEN FACE

DRIVEN FACE

OUTER BEARING

SNAP RING

SEAT SIDE

INNER BEARING

(NEEDLE)

OUTER BEARING

SNAP RING

GREASE

APPLYING

RANGE

INNER BEARING

BELT TYPE CONTINUOUSLY VARIABLE TRANSMISSION / KICK STARTER

NOTE

•Assemble completely cir clip to the home.

•Input inner bearing by press.

TOOL : Bearing driver attachment

Driver pilot