Specifications

DRIVEN PULLEY SUB ASS’Y

COG

WIDTH

BELT TYPE CONTINUOUSLY VARIABLE TRANSMISSION / KICK STARTER

INSPECTION

● Check the drive belt for cracks, cog seperation and

wear ; Replace as necessary.

● Measure the width of the drive belt →replace the

belt if the service limit is exceeded.

SERVICE LIMIT : 16.5mm

NOTE

·Use only a genuine DAELIM replacement drive

belt.

·Do not get oil or greasde on the drive belt or pulley

side.

·Clean off any grease or oil before reinstalling.

INSTALLATION

● Like left pucture, turn the pulley clockwise and

spread the faces apart while installing the drive belt.

● Hang on drive belt assembled at driven pulley sub

ass’y.

● Between drive face and movable drive face, then

assemble it to drive shaft in reverse side.

● Assemble clutch outer to driven pulley sub ass’y.

● Temporarily install flange nut 10mm to driven pulley,

tighten the nut to the specified torque.

TORQUE : 4.Okgf

・・

TOOL : UNIVERSAL HOLDER

NOTE

·Hold the pulley faces apart preventing them from

closing.