Specifications

7. BELT TYPE CONTINUOUSLY VARIABLE
TRANSMISSION / KICK STARTER
SERVICE INFORMATION
GENERAL SAFETY
● Do not allow oil to contact the drive belt or the pulley face. The transmission rate of driving force is reduced due to
oil contact.
● Do not operate starter motor while the LH. crank case front cover is removed.
NOTE
·Take precautions not ot apply the grease oil to the movable drive face or weight roller.
SPECIFICATIONS
SERVICE INFORMATION
···
7-1
SERVICE STANDARD
·· ··
7-1
TROUBLESHOOTING
·· ··
7-1
LH. CRANK CASE COVER REMOVAL
·
7-2
ITEM STANDARD SERVICE LIMIT
MOVABLE DRIVE FACE BUSHING INNER DIAMETER 20.000~20.021mm 20.10mm
DRIVE FACE BOSS OUTER DIAMETER 19.959~19.980mm 19.91mm
DRIVE BELT WIDTH 17.5mm 16.5mm
WEIGHT ROLLER OUTER DIAMETER 15.920~16.080mm 15.40mm
CLUTCH OUTER AND INNER DIAMETER 107.000~107.087mm 107.50mm
TROUBLESHOOTING
Engine starts but motorcycle does not work.
● Drive belt worn.
● Ramp plate damaged.
● Clutch shoe worn or damaged.
● Movable driven face spring cut.
Engine stops, or the vehicle runs suddenly,
after starting.
● Clutch shoe spring cut.
Vehicle unable to run at the maximum speed,
or lack of output
● Drive belt worn.
● Defective movable driven face spring.
● Weight roller worn.
● Pulley face contaminated.
KICK STARTER
· · · · · ·
7-2
DRIVE BELT
· · · · · · · ·
7-4
DRIVEN PULLEY ASS’Y
· · · ·
7-6
MOVABLE DRIVE FACE
· · ·
7-11