Specifications

FRONT BRACKET
FRONT BRACKET
FRONT BRACKET
FRONT BRACKET
FRONT BRACKET
FRONT BRACKET
FRONT BRACKET
FRONT BRACKET
FRONT BRACKET
FRONT BRACKET
FRONT BRACKET
FRONT BRACKET
FRONT BRACKET
FRONT BRACKET
FRONT BRACKET
FRONT BRACKET
FRONT BRACKET
FRONT BRACKET
FRONT BRACKET
FRONT BRACKET
FRONT BRACKET
FRONT BRACKET
FITTING AT ASSEMBLY
FITTING AT ASSEMBLY
FITTING AT ASSEMBLY
FITTING AT ASSEMBLY
FITTING AT ASSEMBLY
FITTING AT ASSEMBLY
FITTING AT ASSEMBLY
FITTING AT ASSEMBLY
FITTING AT ASSEMBLY
FITTING AT ASSEMBLY
FITTING AT ASSEMBLY
FITTING AT ASSEMBLY
FITTING AT ASSEMBLY
FITTING AT ASSEMBLY
FITTING AT ASSEMBLY
FITTING AT ASSEMBLY
FITTING AT ASSEMBLY
FITTING AT ASSEMBLY
FITTING AT ASSEMBLY
FITTING AT ASSEMBLY
FITTING AT ASSEMBLY
FITTING AT ASSEMBLY
FRONT BRACKET
FRONT BRACKET
FRONT BRACKET
FRONT BRACKET
FRONT BRACKET
FRONT BRACKET
FRONT BRACKET
FRONT BRACKET
FRONT BRACKET
FRONT BRACKET
FRONT BRACKET
FRONT BRACKET
FRONT BRACKET
FRONT BRACKET
FRONT BRACKET
FRONT BRACKET
FRONT BRACKET
FRONT BRACKET
FRONT BRACKET
FRONT BRACKET
FRONT BRACKET
FRONT BRACKET
REAR BRACKET
REAR BRACKET
REAR BRACKET
REAR BRACKET
REAR BRACKET
REAR BRACKET
REAR BRACKET
REAR BRACKET
REAR BRACKET
REAR BRACKET
REAR BRACKET
REAR BRACKET
REAR BRACKET
REAR BRACKET
REAR BRACKET
REAR BRACKET
REAR BRACKET
REAR BRACKET
REAR BRACKET
REAR BRACKET
REAR BRACKET
REAR BRACKET
STARTING SYSTEM
STARTER MOTOR ASSEMBLY
● Install the brush and brush spring to the brush hold
set.
● Apply grease to both ends of the armature shaft, and
install the 2 washers.
● Push the brush, and insert the armature into the rear
bracket groove.
CAUTION
•The sliding surfaces of the brushes can be
damaged if they are not installed properly.
•When inserting the amature into the case, hold the
amature tightly to keep the magnet from pulling
the amature against the case.
● Assemble rear bracket
● Assemble front bracket aligning york.
● Tighten the 2 set bolts.
NOTE
•When installing the cover, take care to prevent
damaging the oil seal lip with the shaft.
•Overtigntening the starter motor cable terminal
nuts may cause the inside the starter motor,
resulting in serious damage to the inner connectors.