Specifications

SPEEDOMETER GEAR BOX

󰤊󰤊

FRONT WHEEL / FRONT BRAKE / FRONT FORK / STEERING STEM

● Align the wheel hub with the projection area of the

speedometer gear box retainer, and install.

● Apply grease to the dust seal rim.

● Install the dust seal, and align the projection area of

speedometer gear box retainer with the gear groove

to assemble the speedometer gear box.

FRONT WHEEL

INSTALLATION

● Insert the front wheel between the front forks.

● Insert the disk, taking precautions not to damage the

pad, and assemble the wheel.

● Align the slots of the speedometer gear with tangs of

the left fork slider.

● Insert the front axle into the speedometer gear box

and the wheel hub.

● Install the axle nut.

● Install the speedometer cable and tighten with

screws.

● Place the front wheel on the ground, and tighten the

axle nut to the specified torque.

TORQUE VALUE : 5.0~7.0kgf

BRAKE DISK INSPECTION

● Check crack or damage of brake disk

● Measure the thickness of brake disk by micrometer.

TSERVICE LIMIT : FRONT 3.5MM

● If the minimum measured is lower than service

limit, replace brake disk.