Owner`s manual

45
SIDE STAND INSPECTION
SIDE STAND
SPRING
● Erect main stand and place vehicle in
up
right position on level ground.
●Check the spring for damage or loss of
tension and the side stand assembly for
freedom of movement.
●Check the side stand ignition cut-off
system;
Put the side stand up.
Start the engine.
Lower the side stand. The engine
should stop as you put the side stand
down.
●If the side stand system does not operate
as described, inspect it in the closest
authorized repair center.
A rubber part is assembled on the cable to
protect the inner cable.
Make sure that this part is placed firmly
around the correct part of the cable. When
washing the car, do not directly spray
water on to the rubber part is dirty, use a
dry cloth to clean this area.
●Make sure to stop the engine prior to car
washing.
●Be careful not to allow water to enter
the muffler during the washing.
Water inside the muffler may cause an
improper engine starting or rust occurr-
ence.
●Do not let water get inside the braking
system during the washing, as water
inside the brake system may weaken the
braking power. Upon completion of
washing, select a safe place where there
is no traffic obstruction, and start the
vehicle.
Lightly apply the brake while driving at
a slow speed and check the braking
power.
If the braking power has been weak-
ened, apply brake lightly while driving
at a slow speed to dry up the brake
system.
●Take precautions when waxing the
vehicle.
Excessive polish of the painted section
and/or the resin part with compound
wax might damage the painted section
causing discoloration of the affected
area.
CAUTION
●Infiltration of the foreign materials
or water caused by damage of
lever(disengagement, tearing, etc.)
may cause freezing in winter
season resulting in faulty operation,
sudden accelation and braking
force decrease. If any damage is
found, replace with the new one
immediately.
CABLE RUBBER PART INSPECTION
INSPECTION
PART
RUBBER
INSPECTION
PART
NOTABLES FOR CAR WASHING
*NS-125DLXO/M 02.11.5 3:41 PM 페이지45