Owner`s manual

44
<REMOVAL>
① Turn the seat lock switch to the right
using the main switch key.
② Loosen the 6 washer screw and remove
the air cleaner case cover.
③ Loosen the 2 washer screw and remove
the air cleaner element holder.
④ Remove the air cleaner element.
<CLEANING>
●Clean the air cleaner element in clean
oil, squeeze excess oil, and then, wra-
pping it in a dry cloth, squeeze it again.
●Make sure all excess oil removed and
reassemble the air cleaner element.
OIL : SAE 10W-30
⑤ Install in the reverse order of removal.
AIR CLEANER ELEMENT
INSPECTION
CAUTION
●Do not use gasoline or ther ma-
terials having a low ignition point
as this can be a fire hazard.
●If the air cleaner element is in
adequately assembled, dust and
other waste materials can directly
enter the engine. This results in
increased cylinder wear and redu-
ced power, and reduced durability
of the engine.
●When washing the vehicle, be
careful not to allow water to get
into the air cleaner.
Difficulties in starting the engine
may result if this happens.
●If the engine start is failed during
rain or after driving across water
pool, check to see if the water is
infiltrated in the air cleaner and
clean it.
BULB
REAR UNDERCOVER
REAR COMBINATION
LIGHT LENS
REAR WINKER
LENS
<REAR WINKER BULB>
① Remove the rear undercover.
② Loosen the 2 screws and remove the
rear combination light lens.
③ Remove the rear winker lens.
④ Slightly press down on the bulb and
turn it counterclockwise.
⑤ Install a new bulb in the reverse order
of removal.
REAR WINKER BULB : 12V 10W
*NS-125DLXO/M 02.11.5 3:41 PM 페이지44