Owner`s manual

<REAR WHEEL REMOVAL>
① Set vehicle on main stand in upright
position on level ground.
② Loosen the rear brake hose setting bolt.
③ Loosen the 3muffler setting bolts, and
remove the muffler.
④ Loosen the rear brake hose setting bolt.
⑤ Remove the rear caliper assembly from
the rear swing arm by removing the 2
fixing bolts.
⑥ Loosen the axle nut, remove the rear
swing arm.
⑦ Remove the collar and the rear wheel.
⑧ Install in the reverse order of removal.
REAR AXLE NUT TORQUE
: 6.0~8.0kgf
··
m
38
CAUTION
●If a torque wrench was not used for
installation, see your authorized
dealer as soon as possible to verify
proper assembly.
Improper assembly may lead to loss
of braking capacity.
CAUTION
●If a torque wrench was not used for
installation, see your authorized
dealer as soon as possible to verify
proper assembly.
Improper assembly may lead to loss
of braking capacity.
AXLE NUT
REAR SWING ARM
FIXING BOLTS
REAR CALIPER
REAR BRAKE HOSE
SETTING BOLT
REAR BRAKE HOSE
SETTING BOLT
FIXING BOLTS
MUFFLER SETTING BOLTS
MUFFLER
*NS-125DLXO/M 02.11.5 3:41 PM 페이지38