Owner`s manual

If engine oil is polluted, it seriously affects
the engine life span. Maintain appropriate
level of oil, use correct type of oil and
observe oil exchange period.
●Stand vehicle on the main stand on level
ground and run engine idle(warm-up)
for approximately 2-3 minutes.
●Stop engine and place a container under
the engine. Remove the drain plug bolt,
and drain engine oil.
●Tighten the drain plug bolt.
●Remove the plug maintenance cover and
fill the engine oil after opening oil filter
cap of cylinder head cover.
OIL CAPACITY : 0.8
ℓℓ
(After oil filter change)
0.75
ℓℓ
(After oil change)
●Start the engine and keep it idle for a
few minutes.
●Stop the engine and check the oil level.
If the oil level is low, add the
recommended engine oil.
●Check on oil leaks.
<RECOMMENDED OIL>
If oil sold on markets or privately ma-
nufactured oil (oil-grade) is used, engine
life is adversely affected, and the privilege
of warranty repairs cannot be guaranteed.
36
CHANGING ENGINE OIL
DRAIN PLUG BOLT
SIGHT GLASS
GRADE(SE, SF, SH)
CAUTION
●If you change engine oil immed-
iately after engine is stopped, be
careful of burns because the engine,
muffler and engine oil are still hot.
●Exercise caution not to allow dust
or other foreign matter to flow in
when refilling engine oil.
●If oil overflows, wipe off oil clean.
If oil level is lower or higher than
prescribed level, engine is adver-
sely affected.
●Do not mix oil with those of
different manufacturers or grade, or
do not use low-quality oil as it may
cause deterioration of oil, leading
to accidents.
●Clean the oil filter screen with fresh
cleaning oil every 4,000km.
●Be careful not to lose the oil filter
screen spring when assembling the
oil drain bolt.
*NS-125DLXO/M 02.11.5 3:41 PM 페이지36