Owner`s manual

<REPLENISHING FRONT BRAKE FLUID>
●Check that the fluid level is above the
LOWER level mark with the motorcycle
in an upright position.
●Brake fluid must be added to the
reservoir whenever the fluid level
begins to reach the LOWER level mark.
1.Remove the screw rivet and take the
front brake fluid maintenance lid off.
2.Clean dust and other foreign materials
around reserve tank to prevent foreign
materials from falling inside tank.
3.Remove the screws and take oil cup cap,
diaphragm plate, diaphragm off.
4.Replenish recommended brake oil to the
upper level inside reserve tank.
RECOMMENDED BRAKE OIL IS
DOT 3 or DOT 4
5.Reinstall the diaphragm plate, and oil
cup cap.
6.Tighten the screws securely.
7.Install the front brake fluid maintenance
lid.
<REPLENISHING RERE BRAKE FLUID>
●Replenish in the same method as that of
front brake fluid replenishment.
34
CAUTION
●When adding brake fluid, be very
careful not to allow foreign matter
to enter the reserve tank.
●Do not fill past upper level.
This can cause brake fluid to leak
out of the reserve tank.
●Do not let brake fluid contact
vehicle parts as this damages
painted areas. If oil contacts parts,
quickly clean the fluid off using a
dry cloth.
●Use recommended brake fluid as
other types can undergo chemical
changes.
●If brake fluid is exceedingly low,
this can be indication of damage to
the brake system.
●A leak in the brake system can lead
to reduced braking efficiency and
possible loss of braking ability.
OIL CUP CAP
DIAPHRAGM PLATE
DIAPHRAGM
SCREW RIVET
BRAKE FLUID
MAINTENANCE LID
SCREW
*NS-125DLXO/M 02.11.5 3:41 PM 페이지34