Owner`s manual

[BULB CAPACITY]
Be sure to use only a bulb of rated
capacity.
[INSPECTION OF STOP LAMP]
Turn a main switch "ON". Check a stop
lamp for proper operation by operating the
front wheel and the rear wheel brakes, and
also a lens for damage or contamination.
[BULB REPLACEMENT METHOD]
●Be sure to turn a main switch "OFF"
prior to replacement of a bulb.
●Use only a bulb of rated capacity.
●After replacement with new bulb, check
for proper operation.
[HEADLIGHT BULB]
●Check a switch for proper contacts prior
to replacement of a bulb.
① Loosen seven bolts and disconnect a
wire, and then disassemble a front
cover.
② Disassemble a headlight rear cover by
pulling it out, and then disassemble a
headlight socket by turning it to
counterclockwise.
43
BULB REPLACEMENT
CAUTION
●Care is to be taken to avoid leaving
fingerprints on a headlight bulb. Failing to
observe this may cause early damage of
the headlight bulb resulted from
concentration of heat.
●Be sure to wear clean gloves when
replacing a bulb. If touched to it with bare
hands, clean it with a cloth soaked with
alcohol to prevent from early damage.
HEADLIHGT
TAIL/STOP LIGHT
FRONT
REAR
WINKER
12V-35/35W
12V-21/5W
12V-RY 10WX2
12V-RY 10WX2
FRONTCOVER
SCREW
SCREW
SCREW