Owner`s manual

[REAR WHEEL REMOVAL]
1. Set vehicle on main stand in upright
position on level ground.
2. Loosen the rear brake adjuster nut and
remove the brake rod from the brake arm.
3. Loosen the drive chain adjusting lock
nuts and adjusting nuts.
4. Loosen the rear brake stopper bolt
securing the rear brake panel.
5. Loosen the rear weel axle nut and
remove the rear wheel axle and the rear
wheel.
6. Install in the reverse order of removal.
REAR AXLE NUT TORQUE : 4.0~5.0kgf.m
●After installing the wheel, apply the
brake several times and then check if
the wheel rotates freely. Recheck the
wheel if the brake drags or if the wheel
does not rotate freely.
●Erect main stand and place vehicle in
upright position on level ground.
●Check the spring for damage or loss of
tension and the side stand assembly for
freedom of movement.
●Check the side stand ignition cut-off
system;
① Put the side stand up.
② Start the engine.
③ Lower the side stand. The engine
should stop as you put the side stand
down.
●If the side stand system does not
operate as described, inspect it in the
closest authorized repair center.
40
SIDE STAND
CAUTION
●After installing the wheel, adjust the
rear brake and drive chain free play.
WARNING
●If torque wrench was not used for
installation, see you authorized dealer
as soon as possible to verify proper
assembly.
Improper assembly may lead to loss of
braking capacity.
ADJUSTERNUTLOCKNUT
AXLENUT
BRAKEROD
BRAKEARM
BRAKEADJUSTERNUT
SIDESTANDSPRING SIDESTANDSWITCH