Owner`s manual
<ADJUSTMENT>
●Drive chain slack should be checked
and adjusted, if necessary, every
1,000km.
●When operated at sustained high speeds
or under conditions of frequent rapid
acceleration, the chain may requir more
frequent adjustment.
1. Place the vehicle on its main stand with
the transmission in neutral and the
ignition switch off.
2. Loose the axle nut.
3. Loose the lock nuts on both sides of the
swingarm.
4. Turn both adjusting nuts an equal
number of turns until the correct drive
chain slack is obtained. Turn the
adjusting nuts clockwise to tighten the
chain or counterclockwise to provide
more slack. Adjust the chain slack at a
point midway between the drive
sprocket and the rear wheel sprocket.
Rotate the rear wheel and recheck slack
at other section of the chain.
Chain slack should be : 20~30mm
5. Tighten the axle nut to specified torque.
AXLE NUT TORQUE : 4.0~5.0kgf.m
6. Tighten the adjusting nuts lightly, then
tighten the lock nuts by holding the
adjusting nuts with a spanner.
38
WARNING
●If a torque wrench is not used for this
installation, see your authorized dealer
as soon as possible to verify proper
assembly.
CAUTION
●Excessive chain slack could cause
the chain to come off the sprockets,
resulting in loss of control or serious
engine damage.
●Make sure the right and left chain
adjuster graduations are set in the
same position.
●After adjusting chain, check the rear
brake pedal free play.
AXLENUT
LOCKNUT
ADJUSTERNUT