Owner`s manual
36
1. Put vehicle in upright position on a flat
ground.
2. Start engine and let in run idle for a few
minutes.
3. Using the throttle stop screw, adjust
idling to prescribed level.
IDLE REVOLUTION:
1,600 100rpm
4. Tighten up pilot screw and loose
backward 3/4.
5. Operate throttle lever lightly and verify
there is no change in the number of idle
running. If there is a change, repeat the
process described in paragraph 3 and 4.
● Adjust the clutch only after turning off
the engine.
① There are two types of clutch ; one-way
clutch and clutch.
② Adjust the clutch as follows ; Loosen
the lock nut and turn the clutch
adjuster clockwise until it stops and
then counterclockwise. At this time,
turn the adjuster 1/8〜1/4 turn from
where the screw get caught and tighten
the lock nut completely.
IDLE SPEED ADJUSTMENT
CLUTCH ADJUSTMENT
CAUTION
●Make sure that the engine is fully
warmed up before adjusting the idle
speed. Improper adjustment can
result in increased engine wear.
CAUTION
●When the adjustment is completed,
the clutch must not slide when
starting the engine and starting using
the kick starter must be obtained
easily. Check if the gear can be
changed easily.
PILOTSCREW
CLUTCHADJUSTER LOCKNUT
THROTTLESTOPSCREW