Owner`s manual
●Check that the fluid level is above the
LOWER level mark with the vehicle in
an upright position.
●Check through access cover which is
observable through inspection groove
located between the front handle cover
and the right end section of headlight.
(Use of a flash is recommended.)
●Brake fluid must be added to the
reservoir whenever the fluid level
begins to reach the LOWER level mark.
1. Remove the screws and take oil cup
cap, diaphragm plate diaphragm off.
2. Replenish recommended brake fluid to
the UPPER level inside reserve tank.
RECOMMENDED BRAKE FLUID
is DOT3 or DOT4
3. Reinstall the diaphragm, diaphragm
plate, oil cup cap.
4. Tighten the screws securely.
Other checks :
●Mark sure there are no fluid leaks.
●Check for deterioration or cracks in the
hose and fitting.
●Check the brake pad for wear when
refilling with brake fluid.
<BRAKE PAD INSPECTION>
Operate brake and, if the brake pad wear
limit line reaches the brake disk side, it
indicates the pad has reached wear limit.
18
CAUTION
●The brake lever must be operated
several times after replacement of the
front brake pad.
SCREWS
UPPER
LEVEL
OILCUPCAP
DIAPHRAGM
DIAPHRAGM
PLATE
WEARLIMITLINE
BRAKEDISK