User's Manual

GreenOK - Wireless Thermo-Hygro Monitor
User’s Manual (Rev 2.0)
12
4. Wireless Sensing Unit
1) Setting up the Sensing Unit
▪ Turn on the power button and sensing unit transmits measuring temperature
and humidity to monitoring unit 3 times while initializing.
2) Transmitting LED
▪ Green LED blinks about 0.1 seconds whenever it transmit.
▪ Symptoms of low battery charge, LED lights off.
3) Sensor number
▪ Sensor numbers are or location of an ID. Please avoid duplication with the same
sensor number.
▪ You can set up to 16 sensor number as like 1, 2, 3, 4, 5, 6, 7, 8, 9, 10(A), 11(B),
12(C), 13(D), 14(E), 15(F), 16(G).
▪ Factory default sensor number is ‘1’.
4) Transmission Interval
▪ It is an interval that measuring results (temperature, humidity) are transmitted.
▪ Programmable transmission intervals are 1min, 2min, 5min, 10min.
▪ Factory default transmission interval is 1 min.
5) Setting the Upper limit of Temperature
▪ The values of temperature more than the upper limit cause alarm1.
▪ Programmable temperatures for the upper limit of temperature are 10℃, 12℃,
14℃, 16℃, 18℃, 20℃, 22℃, 24℃, 26℃, 28℃, 30℃, 32℃, 34℃, 36℃, 38℃,
40℃. You can set among 16 values.
▪ Factory default for upper limit of temperature is 40℃.
6) Setting the lower limit of temperature
▪ The values of temperature less than the lower limit cause alarm1.
▪ Programmable temperatures for the lower limit of temperature are -10℃, -8℃,
-6℃, -4℃, -2℃, 0℃, 2℃, 4℃, 6℃, 8℃, 10℃, 12℃
, 14℃, 16℃, 18℃, 20℃. You
can set among 16 values.
▪ Factory default for lower limit of temperature is 0℃.
7) Power switch
▪ Turn on or off power.