User's Manual

GreenOK - Wireless Thermo-Hygro Monitor

User’s Manual (Rev 2.0)

5. Local Monitoring Unit

1) Setting up the monitoring unit

▪ Power up the monitoring unit and operate like the followings.

・ The LED for Sensor number/temperature/humidity displays 1 to G(16) in

order.

・ All o transmitting LED lights on green and red each just one time.

・ Alarm 1 and alarm 2 sounds for a few times.

▪ After initializing, the LED of monitoring unit is all out and the LED for sensor

number/temperature/humidity displays “_ _ _ _”.

2) Sensor No. LED

▪ Each monitoring unit has its own sensor number.

▪ Sensor number automatically rotates 1,2,3,4,5,6,7,8, 9, A, B, C, D, E, F, G and

displays temperature/humidity for each of them. Each sensor displays at 4

seconds intervals.

3) Temperature LED

▪ Each sensing unit has its own sensor number and displays temperature “℃”.

4) Humidity LED

▪ Each sensing unit has it’s own sensor number and displays humidity “%”

5) Transmitting signal LED

▪ When sensing units normally transmits, LED lights green.

▪ If sensing unit has a temperature lower than the lower limit or more than the

upper limit, the LED of monitoring unit blinks on red at 0.5 seconds intervals.

▪ When monitoring unit can’t receive any results from sensing unit over presented

interval, LED turns on red.

▪ 2 hours after alarm occurred and if it is not all clear, LED of alarm relevant to

sensing unit is out.

▪ The LED of not existed sensing unit is not light on.

6) Sensor No. rotate button

▪ If you want to check next sensor No., press this button.

7) Mute

▪ If alarm occurred, you can press the button to mute the sound.

▪ After 10 minutes of mute, if it is still in warning condition, alarm will be occurred

again.

8) Alarm off

▪ Alarm is let you know in abnormal temperature and situation of sensing unit.

You can slide this switch to right to do not sound alarm at all.

▪ Factory default (and for general use) the switch is alarm-on.

▪ If the button sets up alarm off, it has no sound but LED displays still in warning.

9) Buzzer/Alarm operation

▪ If sensing unit has a temperature lower than the lower limit or more than the

upper limit, Alarm1 will be occurred every 0.3 seconds.

▪ If transmitting is abnormal, alarm2 will be occurred every 2 seconds.

▪ Alarm will be occurred until press the mute button or slide the alarm-off switch.

10) Power Adapter