Manualshelf

Getting Started Guide

ManualsBrandsDAD ManualsDigital Audio Converters & AccessoriesMOM - Monitor Operating Module - First-grade hardware monitor controller
12345678910
Getting Started Guide MOM
Doc no. MOM-8002-A-4 Rev. date 180220
Page 6 of 13
Figure 3, Front view of the MOM
Note. The status LED (Stat.) will flash red when the MOM is unconfigured. Once
configured, it will light green.
Configuration
The MOM is configured with the DADman software ver. 5.2 or higher. The following instructions assume
you are already familiar with the DADman software, otherwise please refer to the AX32 User Guide to
familiarise yourself with the software.
Please follow these steps to configure the MOM.
Connecting the MOM
Connect the MOM to the network and make sure it is powered via either PoE or the power adapter. The
Stat. LED will blink red after approx. 2 sec.
In DADman, go to the Device List. The MOM should be detected automatically by the DADman software,
otherwise click on “Refresh”.
The MOM is shown as Unit Type 710, as shown on the following screenshot.