Specifications

7
Cooktop/Range Installation
WARNING:
1. The cooktops and ranges
have very different installation
requirement. Please make
sure you read the Installation
Instructions for the
accompanying cooktop/range
thoroughly before continuing
the installation process.
2. After the cooktop/range
has been installed ensure
that the top cap on the vent
intake does not catch on the
back edge of the cooktop/
range when the intake is
lowered. If interference does
occur, adjust the position
of the cooktop by moving
it against the front edge of
the countertop cutout, then
re-secure the cooktop to the
countertop. Also, ensure that
the vent anchoring legs have
been properly secured to the
cabinet base using the screws
provided in the instructions
envelope. Failure to eliminate
interference may result in
permanent damage to the
vent.
Verifying the Operation
WARNINGS:
1. If the vent system is not
operational after completion
of the installation, do not
attempt to repair it. See the
Problem Solving section of the
Use & Care Manual, then call
a qualified service technician
if the system is still not
functional.
2. Always disconnect the
appliances from the electrical
power when servicing them.
3. Install the two (2) front filters
and the grill prior to operating
the vent. Refer to the Use &
Care Manual for instructions
regarding filter and grill
installation.
• Press the top cap up/down switch
once to raise the ERV to its operating
position.
• In the up position, turn the variable
speed control switch in both direction
to verify that the blower is operating
correctly.
• Turn the variable speed control switch
counter-clockwise to hi-speed and
clockwise to low speed.
• Press the top cap up/down switch
once to lower the ERV pinnacle.