cacor ~—epemewmmemtne Part No. 105671 Rev.
Table of Contents Important Safety Instructions .........cccceeeee About Safety Instructions .......... eee Safety Symbols and Labels ................ccccceeees General Safety Precautions .................cccccee Product Specifications ............cccccceceeeeeeeeeeeeeees Product Dimensions ..............::ccceeeeesereeeeeeeees Preparing for Installation.............ccccecceceeeeeeeeeer Electrical Specifications 0.0.0... cccceneeeeee Water Supply Specifications .............ccceees Preparing the Location...
Important Safety Instructions Important Information About Safety Symbols and Labels Safety Instructions DANGER The Important Safety Instructions and warnings in these instructions are not meant to cover all possible problems and conditions that can occur. Use common sense and caution when installing, maintaining or operating this or any other appliance. Always contact the Dacor Customer Service Team about problems and conditions that you don’t understand. See Customer Service Information.
Important Safety Instructions General Safety Precautions WARNING - To reduce the risk of fire, electric shock, serious injury or death when using your appliance, follow basic safety precautions, including the following: WARNING Use this dishwasher only forits intended purpose as outlined in the:use and care manual. It is not intended for commercial use. Read the use and care manual completely before use. Do.not install: or-operate this dishwasher.
Product Specifications Product Dimensions Style varies, model RDW24S shown Y __ ~< v Depth with door open +«—— 49 3/4” (126.4 cm) Depth with door closed > dh Product tolerances: +1/16” (£1.6 mm) \- Cc D Handle depth >| A Se) . h I> Drain hose Sid Front Depth dimensions allow Ide for hose on back of unit B _—_ 6 1/4” (15.9 cm) to 81/4" (21.0em) 4 |] y sd [Dan T° YY Shipping weight: 117 lbs. (53 Kg) qT «—1 15/16” (4.
Preparing for Installation WARNING Grounding Observe.all.governing codes and ordinances. during planning and insiallation. Contact your local building departmeni for further information. Electrical Specifications WARNING Electrical‘and grounding connections must comply with the applicable portions of the national-electrical code and/or other local electrical codes. This dishwasher comes with an electrical cord with a three prong grounding plug for a 120 Vac, 15 Amp. power supply.
Preparing for Installation Preparing the Location Cutout tolerances: +1/16” (+1.6 mm), -0 WARNING Follow all cabinet dimensions shown to insure safe operation. All minimum product dimensions must be met or-exceeded (see page 3). Dimensions shown provide the required clearances. ¢« The cabinet must enclose the dishwasher on the ye (5.1 cm) ye (10.2 cm) top, back and both sides. * Carefully check the location where the dishwasher is to be installed.
Preparing for Installation Custom Door Panel/Handle for Model RDW24I * * The custom panel mounting screws are provided with the dishwasher. Follow the template included to ensure that the panel and the accompanying fasteners will fit properly. The handle and handle mounting hardware are not included with model RDW24lI. A handle designed for use with an appliance should produce satisfactory results. Do not use a knob or handle attached by a single fastener. Instead use a handle with a larger D-style pull.
Preparing for Installation Disposer Disposer connection connection «—— Air gap 2” dia. max. 20" min. 2” dia. max. \ \ Keep higher than disposer connection Keep higher than disposer 35” max. Sink trap connection 20” min. Sink trap max. Floor Floor Disposer Installation without Air Gap Disposer Installation with Air Gap Waste tee Waste tee @— 2” dia. max. 20” min. 35” k Air gap 2” dia. max, ‘ \ Keep higher than waste tee connection Keep higher than waste tee connection Sink tr
Installation Verify the Package Contents Remove all styrofoam and plastic wrap from the dishwasher. Be sure to remove the toe kick from the top of the dishwasher packaging. With the assistance of at least one person, remove the dishwasher from the shipping pallet. Place the unit to the side of the cabinet opening. NOTE: Since each dishwasher is tested at the factory for proper operation, there may be some residual water inside the unit, the water supply line or drain hose.
Installation Instructions Installation Preparation WARNING Before working on wiring for-any electrical appliance, be.sure the power has been turned off-at the breaker/fuse box.-Place a tag at the disconnect switch indicating that you are working on the circuit. 3/8” screw, included, 2 places 2 Moving this appliance requires two.people.:Do not attempt to install or-lift it alone. y To prevent.personal injury, wear hand protection when moving this appliance. Do.
Installation Custom Door Panel Installation (cont.): 5. Open the door slightly and use the six (6) supplied 1 3/4” screws to secure the panel to the door through the back. 6. Slide the bottom of the door frame up until the black trim around the exhaust vent just touches the panel. To prevent damage to the dishwasher or panel, make sure the exhaust vent is not blocked. Tighten both screws. eo S Step Attach custom 1 3/4” screw back of door, 5: panel with through 6 places Instructions 3.
Installation 6. Reattach the front end of the spring by pulling it up and forward to fasten it in the mount. Instructions 2. Adjust the feet, until the front of the dishwasher measures 1/8” (3.0 mm) shorter than the cutout height. = 7. Measure the height of the front and back of the cutout with a tape measure. Open the door and check the spring tension again. If necessary, make further adjustments. Leveling the Dishwasher Open the door and pull the bottom rack out of the dishwasher.
Installation Connecting the Wiring Instructions ; Permanently Connected Appliance Only: Connect the ground (green) wire on the cable using a loop or spade terminal to the ground connection screw located on the dishwasher If the cord is not long enough, or if a hard-wire chassis. installation is needed, follow the steps below to complete the electrical connection. Otherwise skip 7. . Junction _4,— to Installing the Unit in the Cabinet.
Installation Installing the Unit in the Cabinet 1. Position the dishwasher in front of the cutout. Make sure the drain hose, water supply line and power cable are positioned in the utility cutouts and are routed to the side they will be connected. Drain hose Power cable \ |, 2” dia. max. max. Water \ CAUTION The-unit has a float switch in the to protect against flooding. If the connection-on the dishwasher. is properly, water may:leak into the activate the float switch. base.
Installation Drain Line Connection CAUTION +. . For-proper dishwasher operaiion and drainage, the drain line must be routed through the bottom of the cabinet and up to the drain or airgap connection. The drain hose or air gap outlet must connect above the sink trap. Instructions 5. cable, water line and drain hose are free of pinches or kinks. 6. 2. If the drain will connect to a waste disposer, see the disposer manufacturer’s installation instructions for correct drain hose mounting techniques.
Installation Final Leveling 1. Attaching the Anti-tio Brackets Check to make sure that adjacent drawers and cupboards can be opened when the dishwasher door is open. Reposition the dishwasher if necessary. Check that there is a 1/8” (3.0 mm) space between the top of the dishwasher door and the underside of the cabinet. [= Instructions CAUTION Make sure to anchor. one anti-tip bracket on each side of the dishwasher. 1.
Installation Installing the Toe Kick 1. Instructions Installation Checklist Loosen the brackets for the toe kick by moving the gray catches toward the center of the dishwasher. WARNING To ensure a ‘safe and proper installation, the following checklist should be completed by the installer to-ensure that no. part of the installation has been overlooked and the unit is working properly. Proper installation .is the responsibility of the homeowner.
cdacor Item No., 80 933 28 Rev. 02 The Life of the Kitchen® Dacor e 600 Anton Bivd. Suite 1000 Costa Mesa, CA 92626 Phone: (800) 793-0093 e Fax: (626) 403-3130 e www.dacor.
