Installation Instructions Preference Cooktop ® Models: SGM304, SGM365, SGM466 Part No. 65141 Rev.
Table of Contents Important Safety Instructions........................................... 1 Important Information About Safety Instructions............... 1 General Safety Precautions.............................................. 2 Installation Specifications................................................. 3 Product Dimensions.......................................................... 3 Electrical Requirements.................................................... 4 Gas Supply Requirements....................
Important Safety Instructions Important Information About Safety Instructions IMPORTANT: If you smell gas: • • Do not use or light any appliance. • Do not touch any electrical switch or use any electrical devices, including the telephone, in your building. • From a neighbor’s phone, immediately call the gas supplier. Follow the gas supplier’s instructions. • If you cannot contact the gas supplier, call the fire department.
Important Safety Instructions General Safety Precautions To reduce the risk of fire, electric shock, serious injury or death when using your appliance, follow basic safety precautions, including the following: WARNING • Read the accompanying use and care manual completely before operating this appliance. • Keep packaging materials away from children. Plastic sheets and bags can cause suffocation. • If you receive a damaged product, immediately contact your dealer or builder.
Installation Specifications warning Observe all governing codes and ordinances during planning and installation. Contact your local building department for further information. Product Dimensions All tolerances ±1/16” (±1.6 mm) unless otherwise noted.
Installation Specifications Electrical Requirements warning To prevent an electric shock hazard, the power supply must meet the specifications stated below. It is the owner’s responsibility to make sure that the electrical service meets electrical requirements and that the electrical outlet has been properly installed by a licensed electrician. • • The cooktop is supplied with a factory installed, 40-inch, three-prong, grounding electrical plug.
Installation Specifications Cabinet and Countertop Layout • warning • • • To reduce the risk of personal injury caused by reaching over a hot appliance, avoid locating cabinet storage space directly above the cooktop. • Failure to meet or exceed the maximum and minimum dimensions/clearances stated in these instructions may result in a fire hazard. • Follow the countertop manufacturer’s instructions regarding the minimum corner radius, use of heat reflective tape, reinforcement of corners, etc.
Installation Specifications Cutout Dimensions All tolerances +1/16” -0 (+1.6 mm, 0) unless otherwise noted. IMPORTANT: Be careful to use the correct cutout diagram (on the facing page) to determine the countertop dimensions for the installation type. Carefully double check all dimensions against the table below and the correct diagram before cutting the countertop.
Installation Specifications Rear wall Vertical combustible surface 4 1/4" (108 mm) Min. from mounting surface to combustibles below cooktop chassis C E 7 1/2" (191 mm) Min. to combustible side wall above countertop (both sides) D 1 7/8" Min. (48 mm) Figure 1 - Square Countertop Cutout Diagram 4 1/4" (108 mm) Min. from mounting surface to combustibles below cooktop chassis Rear wall H Vertical combustible surface G C F H E 7 1/2" (191 mm) Min.
Installation Instructions Verify Package Contents • Hold down brackets (2) • Gas pressure regulator • Grates (2 for SGM304, 3 for SGM365 and SGM466) • Burner sets (4 for SGM304, 5 for SGM365, 6 for SGM466) • Stainless steel cleaner (stainless steel models only) • Igniter cleaning brush Connecting the Gas Line warning • Verify that the gas supply meets specifications before connection. See page 3. • Do not install or use the cooktop without the included gas regulator installed.
Installation Instructions Installing the Burner Components Verifying Proper Operation warning warning • Never attempt to operate the cooktop with any of the burner parts removed. • Do not attempt to adjust the burner air mixture settings. All adjustments are preset at the factory. 1. Remove the burner heads, burner rings, burner caps and grates from their shipping packages. 2. Install the burners as shown.
Installation Instructions Verifying Proper Operation (Cont) Installation Checklist • Once the burner lights, rotate the control knob counterclockwise from HIGH to LOW to adjust the flame height progressively. • When the unit is installed properly, the flame will be steady. It will also have a sharp, blue inner cone that will vary in length proportional to the burner size. The flame will be reduced by the Smart Flame™ feature under the grate fingers to increase grate life.
Wiring Diagrams 11
Wiring Diagrams 12
Wiring Diagrams 13
Dacor ● 1440 Bridge Gate Drive, Diamond Bar, CA 91765 ● Tel: (800) 793-0093 ● FAX: (626) 403-3130 ● www.Dacor.
