Specifications

UNPACKING AND INSTALLATION INSTRUCTIONS

• Phillips Screwdriver

• Electric Drill

• 1/2”, 5/8” and 3/32” Drill Bits

• 1-1/2” Wood Bit or Metal Hole Cutter

(if metal cabinet is used)

• Saw to cut exhaust opening

(if needed)

• Protective Drop Cloth for product and

range - you may also use carton for

protection

• Scissors

• Pencil

• Measure

•Tape

Figure 4

Parts shown not to common scale.

ITEM NAME QUANTITY

1 Wood Screw 5 X 30 mm 6*

2 Toggle Bolt with nuts #10 - 24 X 50 mm 4**

3 Top Cabinet Screw 5 X 60 mm 2

4 Power Cord Hanger 1

5 Tapping Screw 4 x 12 mm 8

6 Flat Washer 30 mm diameter 2

7 Grommet 1

8 Rear Cushion 1

9 Exhaust Damper Assembly 1

! Scale Plate Spacer 2

" Grease Filter 2

# Deflector 1

The INSTALLATION HARDWARE items 1 - 7 are in a small bag. Items 8 - " are packed separately. All items

are in a small carton packed below the oven.

5 TOOLS RECOMMENDED FOR INSTALLATION

6 INSTALLATION HARDWARE

* Must use two - may use remaining four. **May not use all depending on stud location.