Specifications

11
Installation Instructions
Installation Checklist
WARNING
To ensure a safe and proper installation, the follow-•
ing checklist should be completed by the installer
to ensure that no part of the installation has been
overlooked.
Proper installation is the responsibility of the home-•
owner. The importance of proper installation of your
Dacor range hood cannot be overemphasized.
Is the blower assembly mounting bracket properly
□
attached to the wall according to the instructions on
pages 6 and 7?
Is the blower assembly tightly secured to the mount-
□
ing bracket with the machine screws (see page 8)?
Is the duct work completely installed? Are all joints □
attached with sheet metal screws and wrapped with
duct tape (see pages 4 and 7)?
Is the range hood wired and grounded according to □
these instructions and in accordance with all appli-
cable electrical codes (see pages 4 and 9)?
Is the tempered glass hood attached to the blower
□
assembly as specified in this manual (see page 10)?
Are the filters properly installed according to the use □
and care manual?
Has proper operation been verified? □
Has the warranty been activated on-line or the war- □
ranty card filled out completely and mailed?
Verifying Proper Operation
Turn on power at the junction or fuse box.1.
If the control panel is not lit, turn on the main power 2.
switch located next to the light fixture on the under-
side of the hood.
Touch the light key. Verify that all the lights come on. 3.
Touch the light key again to turn the lights off.4.
Touch the blower “5. +” key once and release. Verify
that one light is showing on the blower speed indica-
tor and that the blower is on at low speed.
Touch and release the blower “6. +” repeatedly, three
times. Verify that with each touch of the key the num-
ber of lights on the blower speed indicator increases
and that the blower speed increases.
Touch and hold the blower “7. -” key until the blower
turns off.
If the hood fails to operate properly:
Verify that power is supplied to the hood.•
Check the electrical connections to ensure that the •
installation has been completed correctly.
Repeat the above test.•
If the hood still does not work, contact Dacor •
Distinctive Service at [phone]. Do not attempt
to repair the appliance yourself. If you need service,
be sure to have the model and serial numbers avail-
able when you call. See the inside cover for location.
Do not attempt to repair the appliance yourself. Dacor
is not responsible for the cost of correcting problems
caused by a faulty installation.