Specifications

installing the Chimney (Cont.)
5. Carefully put the chimney over the blower assembly,
taking care not to scratch the surfaces. Make sure
the wiring is tucked in behind the chimney.
6. Lock the tabs inside the chimney bottom into the slots
on the bottom of the blower assembly.
Tabs on inside
of chimney
.
.
Lock tabs
on inside of
chimney into
slots on blower
assembly
Slide the top of the chimney up toward the ceiling.
Line up the holes on the side of the chimney, near
the vents, with the holes on the side of the chimney
mounting bracket.
Attach the top of the chimney to the mounting bracket
using two sheet metal screws, one on each side.
Chimney mounting
_- bracket
Chimney
Installing the Glass Hood
J
opeopiel
stance j
1. Locate the hood mounting hardware. Jt consists of:
¢ 4 thumb screws
¢ 4 pmasticwashers
¢ 4 plastic spacers
2. For easier hood installation, assemble all the thumb
screw hardware before lifting the hood into position.
, Hold each thumb screw with the threads up.
, Put the plastic washer on the thumb screw.
, Put the plastic spacer over the end.
3. Lift the glass hood into place. Line up the holes on
the glass with the mounting holes on the bottom of
the blower assembly.
4. Insert all four thumb screws into the bottom of the
glass and tighten into place.
10 J_c_r