Setup guide

6
Wiring Diagrams
We have provided basic wiring diagrams for a wired or wireless camera.
Back of DKEC
Back of DKEC
Video Camera
To 120VAC
Wireless Base Unit
Example Model:
X10.com, VR31A
To 120VAC
Wireless Camera
Example Model:
x10.com, XC10A
Addressable Power Supply
Example Model:
x10.com, XM10A
Wiring Diagrams
Support and Registration
Registering a New DKEC
IMPORTANT:
This section assumes that
the DKEC unit has been fully
configured for either Broadband,
Wireless or Dial-Up connectivity.
If this is not the case, please refer
to the appropriate section in this
manual for configuration details.
Before going online with the DKEC for the first
time, you are given the opportunity to register
the unit.
• If you are the installer, you should choose
the Register Later button, and allow the
owner to complete registration.
• If you are the owner, choose the Register
Now button to ensure that the warranty is
activated and that you receive software
updates.
IMPORTANT:
In order to receive future software
updates, the owner must register
the unit.
Video Mode
Introduction
The DKEC can be connected to a video camera
which you can use to monitor another part of
the house. For example, you can monitor the
activity in a child’s room or see who is at the
front door. You can also use Video Mode to view
video tapes on a VCR or play video games on a
game system. Additionally, you may wish to take
advantage of the higher quality of Satellite or
Digital Cable by using the S-video connection,
which can also be viewed in Video Mode.
NOTE:
If you connect your Satellite or
Digital Cable service to the DKEC
using S-Video, the DKEC remote
or keyboard cannot be used to
change channels in Video Mode.
Continue to use your existing
remote control with the set-top
box.
If you’ve connected both an S-Video and a
composite signal, both are accessible from
Video mode.
To connect an S-Video source
• Plug an S-Video cable from the camera,
VCR, game machine or satellite/cable
receiver into the S-Video connection on the
back of the DKEC. To the right are samples
of wiring diagrams for a wired or wireless
camera.
To view video sources
1. Press the Video mode button.
The composite signal (if any) appears.
2. Press the Video mode button again.
The S-Video signal (if any) appears.