Planning Guide

All specications subject to change without notice.
Phone: [phone]www.dacor.com
PLANNING
GUIDE
7.12
Model Weight
RNHP3012 51 lbs. (23 kg)
RNHP3018
RNHP3612
53 lbs. (24 kg)
RNHP3618 57 lbs. (26 kg)
RNHP4812 70 lbs. (32 kg)
RNHP4818 77 lbs. (35 kg)
WARNING
To reduce the risk of personal injury caused by reaching over a
hot appliance, cabinet storage space located directly above the
range should be avoided.
WARNING
Observe all governing codes and ordinances during planning and
installation. Contact your local building department for further
information. Use only ductwork deemed acceptable by state,
municipal and local codes.
IMPORTANT
See the diagram for minimum installed distance from the hood
to the cooktop surface. The minimum specified distance may
be higher for the particular range or cooktop in use. Check the
manufacturers specifications for the cooktop or range.
E
30” min.*
(76.2 cm)
Electrical
access
* From cooking surface
top
rear
E
Minimum Width of E:
Upper Cabinet Cutout & Appliance Width
Models E
RNHP3012, RNHP3018 30 inches (76.2 cm)
RNHP3612, RNHP3618 36 inches (91.5 cm)
RNHP4812, RNHP4818 48 inches (121.9 cm)
All tolerances: +1/16” -0”, unless otherwise stated.
• The hood must be as wide as the cooktop surface or wider.
• Plan the installation so that all minimum dimensions are met
or exceeded.
• Dimensions given are minimum clearances, unless otherwise
noted.
• All contact surfaces between the hood and any cabinetry or
walls must be sturdy, solid, and at right angles.
• Install the hood and cooking appliance(s) so that they can be
removed if service is required.
Cabinet Layout Dimensions
Meeting Installation Requirements
RNHP
Renaissance
®
30”, 36”, 48” Wide
Wall Mount Range Hood
Document # PG07-009
Revised 04/21/2016 Page 3/4