Installation Manual
4
Installation Specifications
A
Warming
drawer
Warming
drawer
B
3/4" min.*
(1.9 cm)
D
3/4" min.*
(1.9 cm)
36" typ.
(91.4 cm)
120 Vac
electrical
outlet
C
C
Warming
drawer
Cooktop
1 1/2" (3.8 cm)
Typical countertop
3/4” min.*
(1.9 cm)
120 Vac
electrical
outlet
A
36" typ.
(91.4 cm)
B
C
27"/30"/36" Dacor
single wall oven
Warming
drawer
Warming
drawer
Toe kick
D
C
C
D
120 Vac
elect.
120 Vac
elect.
A
3/4" min.*
(1.9 cm)
Model OWD24:
• is
not approved for installation above a wall
oven or warming drawer.
Cutouts Dimensions
Model (A) Cutout Width
(B) Min. Width to
Adjacent Doors/Drawers
(C) Cutout Height
(D) Minimum Vertical Gap
Between Cutouts
Minimum Cutout Depth
DWD30 28 1/2” (72.4 cm) 30 1/4” (76.8 cm)*
9 1/8” (23.2 cm) 1 1/4” (3.2 cm)*
24” (61.0 cm)
EWD24 22 1/2” (57.2 cm) 24 1/4” (61.6 cm)*
EWD27 25 1/2” (64.8 cm) 27 1/4” (69.2 cm)*
EWD30 28 1/2” (72.4 cm) 30 1/4” (76.8 cm)*
ERWD27 25 1/2” (64.8 cm) 27 1/4” (69.2 cm)*
ERWD30 28 1/2” (72.4 cm) 30 1/4” (76.8 cm)*
HWD24PS 22 1/2” (57.2 cm) 24 1/4” (61.6 cm)*
HWD27PS 25 1/2” (64.8 cm) 27 1/4” (69.2 cm)*
HWD30PS 28 1/2” (72.4 cm) 30 1/4” (76.8 cm)*
HWDF30S 28 1/2” (72.4 cm) 30 1/4” (76.8 cm)*
IWD24 22 1/2” (57.2 cm) **
9 1/8” (23.2 cm) 1 1/16” (2.7 cm)IWD27 25 1/2” (64.8 cm) **
IWD30 28 1/2” (72.4 cm) **
OWD24**** 22 5/8” (57.5 cm) 24 1/4” (61.6 cm)*** 11 15/16” (30.3 cm) NA 20 1/8” (51.1 cm)
*Bare minimum spacing for ventilation and to avoid scraping on DWD, ERW, EWD models; **IWD models or OWD24 without optional front-panel kit: Chassis and drawer faceplate are
smaller than cutout; custom front panel mounts to drawer faceplate; height and width of custom front panel must exceed cutout dimensions (A, C above) to cover hole; allow 1/4"
minimum added space on top, bottom and sides from the custom front panel edge to prevent scraping against adjacent doors, drawers, and countertop; ***OWD24 with optional
factory front-panel kit only; bare minimum spacing shown to avoid scraping; gap above and below cutout is 3/4” min. (See ** above for OWD24 with custom front panel); ****OWD24
cannot be installed above/below/adjacent to a wall oven or warming drawer of any types.