Installation Instructions Heritage Warming Drawers EWD24SCH, EWD27SCH, EWD30SCH, HWD24PS, HWD27PS, HWD30PS, HWDF30S, IWD24, IWD27, IWD30, OWD24S Part No.
Table of Contents Important Safety Instructions........................................... 1 Important Information About Safety Instructions............... 1 General Safety Precautions.............................................. 1 Installation Specifications................................................. 2 Verifying the Package Contents........................................ 2 Installation Planning.......................................................... 2 Installing the Support Platform..............
Important Safety Instructions Important Information About Safety Instructions • The Important Safety Instructions and warnings in this guide cannot cover all possible issues and conditions. Be sensible and cautious when installing/maintaining/ operating this or any other appliance. • Always contact the Dacor Customer Service Team about problems and conditions that you do not understand. Safety Symbols and Labels DANGER Immediate hazards that WILL result in severe personal injury or death.
Installation Specifications Verifying the Package Contents C B • (3) mounting screws - PN 83569 • Wire rack with mounting hardware (OWD24 only) (1) PN 83619 (screw), (1) PN 83267 (clamp) Installation Planning Chassis • A qualified technician must install this built-in appliance. Proper installation is the customer's responsibility. • Carefully check the drawer's installation space to ensure the drawer ia easily accessible and that electrical power can be provided to the location.
Installation Specifications Warming Drawer Overall Dimensions* Model Drawer face heights are 10 1/8" (25.7 cm) x width dimension (A); see Warming Drawer Overall Dimensions table (right) for "A" dimensions for all drawer models (A) Drawer Face Width (B) Chassis Face Width (C) Chassis Width EWD24 HWD24PS 24” (61.0 cm) 23 5/8” (60.0 cm) 22 1/4” (56.5 cm) ERWD27 EWD27 HWD27PS 27” (68.6 cm) 26 5/8” (67.6 cm) 25 1/4” (64.1 cm) DWD30 ERWD30 EWD30 HWD30PS HWDF30S 30” (76.2 cm) 29 5/8” (75.
Installation Specifications Warming drawer 36" typ. (91.4 cm) D Warming drawer D 120 Vac electrical outlet Warming drawer A B C 3/4" min.* (1.9 cm) Warming drawer 36" typ. (91.4 cm) A B (A) Cutout Width (B) Min. Width to Adjacent Doors/Drawers DWD30 28 1/2” (72.4 cm) 30 1/4” (76.8 cm)* EWD24 22 1/2” (57.2 cm) 24 1/4” (61.6 cm)* EWD27 25 1/2” (64.8 cm) 27 1/4” (69.2 cm)* EWD30 28 1/2” (72.4 cm) 30 1/4” (76.8 cm)* ERWD27 25 1/2” (64.8 cm) 27 1/4” (69.2 cm)* ERWD30 28 1/2” (72.
Installation Specifications Installing the Support Platform Provide a platform (100-lb. load capacity) within the cabinet upon which the warming drawer will be supported; 3/4” (1.9 cm) thick plywood is recommended. The platform must be installed level and straight. (No provision is made for leveling the drawer after installation.) NOTE: If the drawer is installed out of level, it may slide open on its own or may not seal tightly, thus limiting the drawer's ability to warm food.
Installation Instructions WARNING • T o avoid personal injury caused by the appliance falling forward when the drawer is opened, secure the chassis to the cabinet and support platform as instructed. • Be certain that the power plug is disconnected from the electrical outlet before installation. • Verify that the electrical supply matches the ratings found on the appliance data plate and the installation specifications before proceeding.
Installation Instructions Re-installing the Drawer 1. Pull the drawer slides all the way out of the drawer opening. 2. Gently lower the drawer between the extended slides until it is suspended by them. 3. Slide the back of the drawer mounting brackets under the drawer mounting clips on the slides. 4. Push one side of the drawer down onto its locking tab, until the tab locks into place. 5. Repeat the same process on the opposite side. 6.
Installation Instructions Warming Drawer Control Panel Layout Verifying Function Installation Checklist 1. Connect power plug to the electrical outlet. 2. Open the drawer and press the ON/OFF key on the control panel. 3. Press the PROOF, LOW, MED and HIGH keys each in turn. When you press each key, the indicator directly above it should light. Leave the control panel set to HIGH. 4. Press the SELECT key. The 1 HOUR indicator should light. Press and release the SELECT key three (3) more times.
Notes 9
Dacor ● 14425 Clark Avenue, City of Industry, CA 91745 ● Phone: (800) 793-0093 ● Fax: (626) 403-3130 ● www.dacor.
