User Manual

3
Model RNF241WCL: Hinges on left, handle on right
Model RNF241WCR: Hinges on right, handle on left
Features
The right environment for your wines...
A vine is an extremely sensitive plant. Grape quality is
dependent on three factors: light, air humidity and ambient
temperature. This sensitivity continues even after the wine is
bottled. To allow a wine’s flavor to fully develop and to preserve
the excellent aroma, it has to be properly stored. Your wine
cellar offers the best storage environment:
 A wide temperature range: The unit has a wide tempera-
ture adjustment range. It allows you to store wine at low
temperature for superb aging or at a higher temperature
for serving wine lightly chilled. The temperature can be set
between 41 to 72°F (5 to 22°C).
 High storage capacity: High storage capacity allows you to
preserve the flavor of your favorite wines. Your wine cellar
can store up to 46 bottles of wine (750 mL each).
 Low Vibration Cooling System and Storage: Wines
require a tranquil environment. The latest technology of your
wine cellar provides virtually vibration free cooling, helping
to preserve wine taste. In addition, the sliding beech wood
storage shelves also provide additional vibration absorption.
Additional Features
• Automatic defrosting system
• Soft white LED interior lighting with on/off switch
• Open-door and malfunction warning system
• Double-layer, UV resistant, tempered glass door, shields
wines from UV rays harmful to wine.
• Door lock
Getting to Know Your Wine Cellar






Racks/Shelves (see diagram above)

Wood slide-out racks: Hold up to eight bottles of wine each

Bottom shelf: Holds up to six bottles of wine
Operating Your Wine Cellar
°F
°C
    
The Control Panel

ON/OFF key

LIGHT key

Temperature display

Temperature UP key

Temperature DOWN key
Turning the Power ON and OFF
• Clean your appliance before turning it on for
the first time. See the Care and Cleaning
section.
• Connect the power cord to the electrical
outlet. The unit will come on.
• To turn the unit off, touch and hold the
ON/OFF key for about five seconds. The display will turn off
to indicate that the appliance is off.
• To turn it on, touch the ON/OFF key until the display lights up.
IMPORTANT: This unit has a compressor reset delay circuit
designed to protect the compressor when it is warm. If the unit
will not start, disconnect the power cord for 5 minutes, then
reconnect.
Setting the Temperature
• Touch the UP or DOWN key repeatedly to raise or lower the
temperature. You can change the settings in
increments of 1°F (or 1°C). The temperature
setting will flash on the display while you
change it.
• After five seconds the display will stop
flashing and the actual temperature of the
compartment will be displayed.
NOTE: Depending on the amount of
temperature change, it may take a few
minutes to a few hours for the compartment
temperature to reach the newly adjusted
temperature level.
Changing the temperature scale (ºF or ºC)
You can select the temperature scale that the unit uses to
display the temperature settings:
• Touch and hold the LIGHT key for about five seconds. The
temperature scale indicator light on the
right side of the display will change to
indicate the new temperature scale. Touch
and hold the LIGHT key again to change
back.
UP Key
DOWN key
°F
°C
°F
°C
LIGHT Key
°F
°C
°F
°C
ON/OFF key