planning guide
PLANNING
GUIDE
All specications subject to change without notice. www.dacor.com Ph. 800.793.0093
Heritage
®
30” Wide
Epicure Gas Range
Page 2 of 3
All tolerances: ±1/16” (±1.6 mm), unless otherwise stated.
HGER30S
Electrical Requirements
WARNING
• Observe all codes and ordinances during planning and installation.
Contact the local building department for details.
• To prevent electric-shock hazard, the power supply must meet
the specifications stated below. The owner shall ensure that the
electrical service meets electrical requirements and that the outlet
is properly installed by a licensed electrician.
• The range must be electrically grounded per local codes, or, in
their absence, with the National Electrical Code, ANSI/ NFPA 70.
• The range’s 6-ft. power cord has a 3-prong grounding plug for
connecting to a dedicated, grounded, 3-prong electrical outlet.
• The correct voltage, frequency and amperage must be supplied
to the range from a separate, grounded circuit that is protected
by a properly sized circuit breaker or time-delay fuse.
Circuit Required Total Connected Load*
120 Vac, 60 Hz, 15 Amp. 120 Vac 60 Hz, 5.0 Amp.
*These specifications for reference only. See the rating label for exact
specifications (see inside front cover for label location).
Gas-Supply Requirements
• Range installation must follow local codes or, in their absence,
the National Fuel Gas Code, ANSI Z223.1/NFPA 54.
• Ensure the range matches the home gas service (natural or LP).
• If installed above 4000 ft. (1219 m) elevation, the range must be
equipped for high-altitude use. (See the inside front cover.)
Power
cord
Gas inlet
• This table provides gas-supply pressure requirements:
GAS-SUPPLY PRESSURE REQUIREMENTS*
Gas Type
Minimum
Manifold Pressure
Minimum Gas-Supply
Pressure**
Natural gas 5” water column 6” water column
Liquid propane (LP) 10” water column 11” water column
*The gas-supply pressure for testing the regulator setting shall be at least 1”
water column (249 Pa) above the specified manifold pressure; **maximum
gas supply pressure for all models: ½ psi.
These ratings are for reference only. See the rating label for exact information.
• Use only the factory-installed regulator. Its inlet receives a ¾”
gas line. A ½”-to-¾” adapter is connected to the regulator.
Rating
label