All specifications are subject to change without notice. Dacor® assumes no liability for changes to specifications. © 2007 Draco, all rights reserved.
Table of Contents Before You Begin Important Safety Instructions General Safety Precautions Installation Specifications .. Verifying the Package Contents. Installation Install a Support Platform in the Cabinet. Electrical Power Supply Installation Instructions Remove the Drawer . Installing the Chassis Re-installing the Drake Verifying the Warming Drawer Operation . Installation Checklist oo~~~ Before You Begin...
Important Safety Instructions General Safety Precautions To reduce risk of fire, electric shock, serious injury or death when using your appliance, follow basic precautions, including the following: WARNING WARNING Read this manual completely before using this Appliance. Rise this appliance only for ils intended use as described in this manual. Use it only to warm food and heat plates and utensils 1 1s not designed for commercial, industrial or laboratory use.
Installation Specifications Verifying the Package Contents e « Use and Care manual ¢ Mounting screws Installation Planning A qualified technician must complete the installation of this built-in appliance. Proper installation is your responsibility. Carefully check the location where the drawer is to be installed. The drawer should be placed for convenient access. Make certain that electrical power can be provided in the selected location.
Installation Specifications “A” Drawer Face “B” Chassis Face | Mods! Width Width C" Chassis Width LEWD 24" (610 mm) 23 5/8" (600 mm) 22 1/8" (562 mm) LEWD MWDH27 ; ] . v2y| 27 (686 mm) 26 /8" (676mm) 25 1/8” (638 mm) PWD27 LEWD MWDH30 " .
Installation Specification ® ° Min. o0 ®| Warming Drawer Beanpole 120 Vac & Warming Drawer [ Draco P! 56 Min. single oven as mm ‘? [— o Warming Drawer 120 Via c Lifi E\ea.c fl ¥ D 1172 (38 mm) Warming Drawer 120 Vac fl T CWK'DP\ /Typist counter top Elect. 4 e 34° Min. ;“ ° ® Warming Drawer I (19 mm) Too Kick 5/8" Min. 120 Vac electrical ® B receptacle o n, D" Min.
Installation Specifications Install a Support Platform in the Electrical Power Supply Cabinet Requirements Provide a platform (100 Ib. load capacity) within the cabinet upon which the warming drawer will be supported. The platform must be installed level and straight. The top edge of the platform must be flush with the cutout at the front of the cabinet. There are no provisions 1o level the warming drawer after it has been installed. 3/4" (19 mm) thick plywood is recommended.
Installation Instructions [A) WARNING To avoid personal injury caused by the appliance {calling forward when the dower is opened, secure the chassis fo the cabinet and support platform as instructed. Ba certain that the prows plug is disconnected from 1he electrical outlet before installation Verify that the electrical supply matches the ratings found on the appliance data piste and the installation specifications before proceeding.
Installation Instructions Re-installing the Drawer 1. 2. STEP 3: Slide mounting bracket under clip on slide Pull the drawer slides all the way out of the drawer opening. Gently lower the drawer between the extended slides until it is suspended by them. Slide the back of the drawer mounting brackets under the drawer mounting clips on the slides. Push one side of the drawer down onto its locking tab, until the tab locks into place. Repeat the same process on the opposite side.
decor The Life of the Kitchen® Draco e 1440 Bridge Gate Drive, Diamond Bar, CA 91765 ¢ Tel: (800) 793-0083 ¢ FAX: (626) 403-3130 ¢ www. Dacor.
