alotee=o Installation Instructions Electric Cooktop For use with models ETT304-1, ETT365-2, MET304 and METB365-1 TESTED IN ACCORDANCE WITH THE LATEST EDITION OF ANSI 221.1 AND UL 858 STANDARD FOR HOUSEHOLD COOKING APPLIANCES. Part No. 65170 Rev.
Table of Contents Before YOu Bein... .........s:sccssssscscsececeseeeseesanananssasanenesesesnes Important Safety INStruUCtiONS ...........ccceccececsnctcrsnsssreneeeeee important Information About Safety Instructions.............. Safety Symbols and Labels 0.0... cccccccccccccccceceeeeeeeeeeneees General Safety Precautions .............ccccccccccccccceceeeeeeeeeeneees Installation Specifications. .............sccececsescsssesssssssseseseeree Product DIMENSIONS ......
Before You Begin... Important: * Installer: In the interest of safety and to minimize problems, read these installation instructions completely and carefully before you begin the installation process. Leave these installation instructions with the customer. * Customer: Keep these installation instructions for future reference and the local electrical inspector’s use.
Important Safety Instructions General Safety Precautions To reduce the risk of fire, electric shock, serious injury or death when tions, including the following: using your appliance, follow basic safety precau- WARNING WARNING Read :the accompanying use and care manual before operating this appliance. To. avoid a fire hazard, do not hang flammable or-heat sensitive objects over the cooktop. Keep packaging materials away from children.-Plastic sheets and bags can cause suffocation. Do.not place.
Installation Specifications Product Dimensions oun All tolerances: +1/16 (£1.6 mm), unless otherwise stated. 4” (10.2 cm) chassis height US 3/16” (4.8 mm) 4” (10.2 cm) chassis height 3/16" (4.8 mm) Models ETT304-1, MET304 (87.3 cm) * For units with stainless steel trim, other units may be up to 1/8” less Electrical Specifications IMPORTANT This appliance is provided with electrical connection leads ‘in a flexible metal conduit. These leads may be a smaller gage.
Installation Specifications Ventilation WARNING ° IMPORTANT: Observe all governing codes and.-ordinances during planning and installation..Contact your local building department for further.information. *-.To-reduce the risk-of a fire hazard, all minimum/maximum.clearances shown must be met or exceeded. «When installing model ETT365-2 or METB365-1 and the bottom of the chassis:is to be enclosed wall to wall, you must install ventilation duct kit ATD323. See the duct installation instructions. for.
Installation Specifications Cabinet Cutout Dimensions Before making the countertop cutout, make certain that the required dimensions shown below have been met or All tolerances: +1/16 (+1.6 mm), -0, unless otherwise stated. A - Overhead Cabinets Clearances: — ayceeded. All Installations that are: A Directly above cooking surface’ 30” (76.2 cm) To left or right of cooking surface’? | 18” (45.7 cm) 1 Cooking surface is 3/16” (4.8 mm) thick. ? Not applicable for cabinets more than 6” (15.
Installation Instructions Verify the Package Contents 4. Secure the cooktop to the countertop utilizing the two (2) hold-down brackets provided. Slide the brackets into the slots located on the left and right sides of the chassis, then tighten the screws to the underside of the countertop. Verify that all the items below have been provided. If any item is missing or damaged, please contact your dealer immediately. Do not install a damaged or incomplete appliance.
Installation Instructions Three Wire Electrical Connection | See diagram on right. Wire nut, 1. Separate the wires coming out of the appliance conduit. 2. Connect the black wire from the appliance conduit to the black (L1) supply wire in the junction box. 3. Connect the red wire from the appliance conduit to the red (L2) supply wire in the junction box. RED Connect the green wire from the appliance conduit to the green (ground) wire in the junction box. GREEN 4.
Installation Instructions Verifying Proper Operation WARNING Read the accompanying use and care manual-completely before using the cooktop. 1. Clean the cooking surface according to the use and care manual prior to use. 2. Turn on the power to the cooktop at the circuit breaker or fuse box. When the unit is powered on for the first time, the cooktop controls will go through a self-check routine. For safety, when the self-check is complete, the cooktop controls will go into locked mode.
Installation OS LAEEEEETrrep Instructions I! ON/OFF of “CESESELELON Vf bey ON/OFF OO OQ —5 OX OT 80 yy O ON/OFF SE LOODEaeereep! ON/OFF ee2ecar Cooktop Controls - Model MET304 8°8 5 ws 6° 5 ws ON/OFF Outer element 6-8 5 is key ON/OFF 6-8 a O ON/OFF O Sw 4 is oS ON/OFF eEcar Bridge element key Cooktop Controls - Model METB365-1 dacor.
; ; The Life of the Kitchen® Dacor e 600 Anton ° Bivd. Suite 1000 Costa Mesa, CA 92626 @ Phone: (800) 793-0093 e Fax: (626) 403-3130 (ge TO RTL a yp Opp ggg Family Owned American Made « www.dacor.
