Specifications

6
ERV/PRV
GRN
GRN
GRN
GRN
WHT
WHT
WHT
BLK
BLK
BLK
REMP
WHT
BLK
120VAC, 60Hz, 15A
48” (1219mm) power cord with
three prong grounded plug
Wiring of ERV/PRV with REMP
Cooktop/Range Installation
WARNING:
1. The cooktops and ranges
have very different installation
requirement. Please make
sure you read the Installation
Instructions for the
accompanying cooktop/range
thoroughly before continuing
the installation process.
2. After the cooktop/range has
been installed ensure that
the top cap on the vent intake
does not catch on the back
edge of the cooktop/range
when the intake is lowered.
If interference does occur,
adjust the position of the
cooktop/range by moving it
against the front edge of the
countertop cutout, then re-
secure the cooktop/range to
the countertop. Also, ensure
that the vent anchoring legs
have been properly secured
to the cabinet base using
the screws provided in the
instructions envelope. Failure
to eliminate interference may
result in permanent damage to
the vent.
Verifying the Operation
WARNINGS:
1. If the vent system is not
operational after completion of
the installation, do not attempt
to repair it. See the Problem
Solving Section of the Use
& Care Manual, then call a
qualified service technician
if the system is still not
functional.
2. Always disconnect the
appliances from the electrical
power when servicing them.
3. Install the two (2) front filters
prior to operating the vent.
Refer to the Use & Care
Manual for instructions
regarding filter installation.
• Press the top cap up/down switch
once to raise the ERV/PRV to its
operating position.
• In the up position, turn the variable
speed control switch in both directions
to verify that the blower is operating
correctly.
• Turn the variable speed control switch
counter-clockwise to hi-speed and
clockwise to low speed.
• Press the top cap up/down switch
once to lower the ERV/PRV pinnacle.
Make all electrical connections between the
vent and blowers, then connect power to the
vent as per the wiring diagrams. Use wire nuts
provided and electrical tape to secure all wiring
connections at the blowers.