Specifications

ManualsBrandsDacor ManualsKitchen AppliancesESG

IMPORTANT

1. Before beginning installation, please thoroughly read and become familiar with these instructions.

2. Installation and service must be completed by a qualified installer or service agency.

3. Installer: Please leave these Installation Instructions with the owner.

4. Owner: Please keep these instructions for local electrical inspector’s use and for future reference.

5. Read the accompanying Use & Care Manual prior to operating this appliance.

TABLE OF CONTENTS

Verifying the package contents Page 2

Installation planning Page 2

Overall dimensions Page 2

Electrical power supply requirements Page 2

Duct Planning Pages 2-3

Countertop and cabinet preparation Pages 4-5

Installing the ERV/PRV Page 5

Connecting the exhaust duct Page 5

Electrical connection Pages 5-6

Cooktop/Range installation Page 6

Verifying the operation Page 6

Part No. 65335 Rev. E

TESTED IN ACCORDANCE WITH THE LATEST EDITION OF ANSI Z 21.1 STANDARD FOR HOUSEHOLD GAS

COOKING APPLIANCES, ANSI/UL 858 HOUSEHOLD ELECTRICAL RANGES, CAN/CSA-C22.2 NO. 64 STANDARD

FOR HOUSEHOLD ELECTRIC COOKING AND LIQUID HEATING APPLIANCES, AND UL 507 ELECTRIC FANS.

NOTES:

Contain helpful hints and tips to facilitate the installation.

CONVENTIONS USED IN THESE INSTRUCTIONS

WARNINGS:

Must be followed carefully to avoid personal injury or damage.

READ AND SAVE THESE INSTRUCTIONS

Installation Instructions

ERV/PRV Downdraft Vent

Summary of content (12 pages)

PAGE 1
Installation Instructions ERV/PRV Downdraft Vent read and save these instructions Tested in accordance with the latest edition of ansi z 21.1 standard for household gas cooking appliances, ANSI/UL 858 household electrical ranges, can/csa-c22.2 no. 64 Standard for household electric cooking and liquid heating appliances, and ul 507 electric fans. CONVENTIONS USED IN THESE INSTRUCTIONS WARNINGS: Must be followed carefully to avoid personal injury or damage.
PAGE 2
IMPORTANT SAFETY INSTRUCTIONS WARNINGS: 1. Read all instructions before using the appliance. 2. Install or locate this appliance only in accordance with these installation instructions. 3. Use this appliance only for its intended use as described in this manual. 4. Do not operate this appliance if it has a damaged electrical cord or plug, if it is not working properly or if it has been damaged or dropped. 5. 6. This appliance should be serviced only by qualified service personnel.
PAGE 3
Verifying the Package Contents Installation Planning • Use and Care Manual • Anchoring Legs A qualified technician must complete the installation of this appliance. Proper installation is your responsibility. Overall Dimensions Raised Vent System Specifications Raised Vent Model No.
PAGE 4
. Thermal breaks, such as a short section of non-metallic duct, should be used in areas of extreme cold. 5. A back-draft damper at the duct outlet may also be required. 6. Do not use flexible metal duct. 7. Do not use ductwork that is smaller in cross-sectional area than the recommended size duct. 8. Do not rely on duct tape alone to seal duct joints. Use sheet metal screws as require to support the duct weight. 9. The raised vent and cooking appliance(s) must be removable if service is required. 10.
PAGE 5
Vertical non-combustible surface rear wall REMP3/16 27 7/8" (708mm) 3/4" (19mm) Max. backsplash 3 1/4" x 10" to Round transition 8” or 10” DIA. Stud wall Wall board 27 13/16" (706mm) 23 3/16" (589mm) 1/4" (6mm) Min. flat ledge 2 13/16" (71mm) Backsplash 3 1/4" x 10" Duct ERV30/ PRV30 Epicure 30 Range 13/16" (21mm) 13/32" (10mm) 29 1/4" (743mm) 30 1/16" (764mm) Countertop overhangs cabinet 6" (152mm) Min.
PAGE 6
Dacor Model No. Cutout “A” Cutout “B” CER304 28 1/2” 27 1/2” CER365 34 1/2” 33 1/2” ETT304 28 1/2” 27 1/2” ETT365 34 1/2” 33 1/2” SGM304 27 1/2” 27 7/8” SGM364 33 3/4” 33 3/4” SGM365 33 3/4” 33 3/4” SGM466 44 1/2” 43 1/2” SGM464GG 44 1/2” 43 1/2” Connecting the Exhaust Duct NOTE: Use duct tape to seal the connection between the blower outlet and duct. Support the duct weight as necessary to ensure sealed joints.
PAGE 7
ERV/PRV GRN GRN GRN WHT WHT BLK 120VAC, 60Hz, 15A 48” (1219mm) power cord with three prong grounded plug BLK WHT BLK REMP BLK WHT GRN Wiring of ERV/PRV with REMP Make all electrical connections between the vent and blowers, then connect power to the vent as per the wiring diagrams. Use wire nuts provided and electrical tape to secure all wiring connections at the blowers. Verifying the Operation Warnings: 1.
PAGE 8
NOTES:
PAGE 9
NOTES:
PAGE 10
NOTES:
PAGE 11
NOTES: 10
PAGE 12
Web Site: www.dacor.